Re: Delivery Status Notification (Failure)

[Russell King - ARM Linux <linux@armlinux.org.uk>]

On Fri, May 11, 2018 at 05:07:37PM +0530, Pintu Kumar wrote:
> Hi,
> 
> I need one help.
> I am using i.MX7 Sabre board with kernel version 4.1.15
> 
> Let's say I am interested in GPIO number: 21
> I wanted to set CPU affinity for particular GPIO->IRQ number, so I
> tried the below steps:
> root@10:~# echo 21 > /sys/class/gpio/export
> root@10:~# echo "rising" > /sys/class/gpio/gpio21/edge
> root@10:~# cat /proc/interrupts | grep 21
>   47: 0 0 gpio-mxc 21 Edge gpiolib
> root@10:~# cat /sys/class/gpio/gpio21/direction
> in
> root@10:~# cat /proc/irq/47/smp_affinity
> 3
> root@10:~# echo 2 > /proc/irq/47/smp_affinity
> -bash: echo: write error: Input/output error
> 
> But I get input/output error.
> When I debug further, found that irq_can_set_affinity is returning 0:
> [    0.000000] genirq: irq_can_set_affinity (0): balance: 1,
> irq_data.chip: a81b7e48, irq_set_affinity:   (null)
> [    0.000000] write_irq_affinity: FAIL
> 
> I also tried first setting /proc/irq/default_smp_affinity to 2 (from 3).
> This change is working, but the smp_affinity setting for the new IRQ
> is not working.
> 
> When I try to set smp_affinity for mmc0, then it works.
> # cat /proc/interrupts | grep mmc
> 295:         55          0     GPCV2  22 Edge      mmc0
> 296:          0          0     GPCV2  23 Edge      mmc1
> 297:         52          0     GPCV2  24 Edge      mmc2
> 
> root@10:~# echo 2 > /proc/irq/295/smp_affinity
> root@10:~#
> 
> 
> So, I wanted to know what are the conditions for which setting
> smp_affinity for an IRQ will work ?
> 
> Is there any way by which I can set CPU affinity to a GPIO -> IRQ ?
> Whether, irq_set_affinity_hint() will work in this case ?

IRQ affinity is only supported where interrupts are _directly_ wired to
the GIC.  It's the GIC which does the interrupt steering to the CPU
cores.

Interrupts on downstream interrupt controllers (such as GPCV2) have no
ability to be directed independently to other CPUs - the only possible
way to change the mapping is to move _all_ interrupts on that controller,
and any downstream chained interrupts at GIC level.

Hence why Interrupt 295 has no irq_set_affinity function: there is no way
for the interrupt controller itself to change the affinity of the input
interrupt.

-- 
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up
According to speedtest.net: 8.21Mbps down 510kbps up