Hi Boris, > Hi Lukasz, > > On Sat, 29 Sep 2018 23:02:40 +0200 > Lukasz Majewski wrote: > > > > Talking about that, can you try to port your fixes on top of > > > Frieder's patchset? I'm pretty sure some bug fixes are irrelevant > > > after the migration to spi-mem (patch 1, 3, 4, 5, 6, 7 and 9 > > > should be dropped I think). > > > > The problem is that Frieder's patch is using IP command mode for > > transfers smaller than AHB RX fifo size. > > This according to the comment in the current driver is broken in HW > > for Vybrid (so this is a regression). > > Why not fixing that in the new driver? I did not say that I will not fix it in the new driver :-) The problem is that I'm waiting for NXP's community reply - to get some more info regarding the bug. > > > > > I'm also wondering if other users of vf610 based boards experience > > issues with QSPI? > > Are you sure the 4 I/O lines are wired on your design? This is a somewhat special case. There are two identical SPI-NOR memories: one with QUAD lines connected and second only for DUAL due to HW design decision. > Anyway, if it's > a bug that only hurts vf610, you should mask quad modes in ->hwcaps > (or patch fsl_qspi_supports_op() in the new driver), not change the > SPI NOR definition. Yes, this was also pointed out by Cyrille - and yes, I do agree that I shouldn't mask it. > > > > > In my case, after running the UBI/UBIFS tests (on the original and > > new driver without those "fixes") I cannot mount the volume after > > creation as the header is wrongly read. > > I'm not denying this fact, I'm just saying, now that you've found > where the issue comes from, you can also port the fix to the new > driver. Yes, as the old driver is now in a "good enough" shape (though I don't know the exact HW bug reason) - the code can be ported to the new driver. > > Regards, > > Boris > > ______________________________________________________ > Linux MTD discussion mailing list > http://lists.infradead.org/mailman/listinfo/linux-mtd/ Best regards, Lukasz Majewski -- DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de