On Thu 2018-10-11 11:51:16, Dan Murphy wrote:
> Remove support for the LM3697 LED device
> from the ti-lmu.  The LM3697 will be supported
> via a stand alone LED driver.
> 
> Signed-off-by: Dan Murphy <dmurphy@ti.com>

NAK.

								Pavel
								
> index c885cf89b8ce..920f910be4e9 100644
> --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt
> +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt
> @@ -9,7 +9,6 @@ TI LMU driver supports lighting devices below.
>    LM3632       Backlight and regulator
>    LM3633       Backlight, LED and fault monitor
>    LM3695       Backlight
> -  LM3697       Backlight and fault monitor
>  
>  Required properties:
>    - compatible: Should be one of:
> @@ -18,11 +17,10 @@ Required properties:
>                  "ti,lm3632"
>                  "ti,lm3633"
>                  "ti,lm3695"
> -                "ti,lm3697"
>    - reg: I2C slave address.
>           0x11 for LM3632
>           0x29 for LM3631
> -         0x36 for LM3633, LM3697
> +         0x36 for LM3633
>           0x38 for LM3532
>           0x63 for LM3695
>  
> @@ -38,7 +36,6 @@ Optional nodes:
>      Required properties:
>        - compatible: Should be one of:
>                      "ti,lm3633-fault-monitor"
> -                    "ti,lm3697-fault-monitor"
>    - leds: LED properties for LM3633. Please refer to [2].
>    - regulators: Regulator properties for LM3631 and LM3632.
>                  Please refer to [3].
> @@ -220,24 +217,3 @@ lm3695@63 {
>  		};
>  	};
>  };
> -
> -lm3697@36 {
> -	compatible = "ti,lm3697";
> -	reg = <0x36>;
> -
> -	enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>;
> -
> -	backlight {
> -		compatible = "ti,lm3697-backlight";
> -
> -		lcd {
> -			led-sources = <0 1 2>;
> -			ramp-up-msec = <200>;
> -			ramp-down-msec = <200>;
> -		};
> -	};
> -
> -	fault-monitor {
> -		compatible = "ti,lm3697-fault-monitor";
> -	};
> -};

-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html