On Thu, Jan 31, 2019 at 02:25:50PM +0100, Paul Kocialkowski wrote:
> When initializing clocks, a reference to the TCON channel 0 clock is
> obtained. However, the clock is never prepared and enabled later.
> Switching from simplefb to DRM actually disables the clock (that was
> usually configured by U-Boot) because of that.
> 
> On the V3s, this results in a hang when writing to some mixer registers
> when switching over to DRM from simplefb.
> 
> Fix this by preparing and enabling the clock when initializing other
> clocks. Waiting for sun4i_tcon_channel_enable to enable the clock is
> apparently too late and results in the same mixer register access hang.
> 
> Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com>

Applied, thanks!
Maxime

-- 
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com