Re: [PATCH v4 15/16] block: sed-opal: don't repeat opal_discovery0 in each steps array

[Christoph Hellwig <hch@infradead.org>]

> +	/* first do a discovery0 */
> +	error = opal_discovery0_step(dev);
>  
> +	for (state = 0; !error && state < n_steps; state++)
> +		error = execute_step(dev, &steps[state], state);
> +
> +	/*
> +	 * For each OPAL command the first step in steps starts some sort of
> +	 * session. If an error occurred in the initial discovery0 or if an
> +	 * error occurred in the first step (and thus stopping the loop with
> +	 * state == 1) then there was an error before or during the attempt to
> +	 * start a session. Therefore we shouldn't attempt to terminate a
> +	 * session, as one has not yet been created.
> +	 */
> +	if (error && state > 1)
> +		end_opal_session_error(dev);
>  
>  	return error;

The flow here is a little too condensed for my taste.  Why not the
plain obvoious, if a little longer:

	error = error = opal_discovery0_step(dev);
	if (error)
		return error;

	for (state = 0; state < n_steps; state++) {
		error = execute_step(dev, &steps[state], state);
		if (error)
			goto out_error;
	}

	return 0;

out_error:
	if (state > 1)
		end_opal_session_error(dev);
 	return error;

Otherwise looks good:

Reviewed-by: Christoph Hellwig <hch@lst.de>