From: Brian Masney <masneyb@onstation.org>
To: linus.walleij@linaro.org, sboyd@kernel.org,
bjorn.andersson@linaro.org, andy.gross@linaro.org,
marc.zyngier@arm.com, lee.jones@linaro.org
Cc: tglx@linutronix.de, shawnguo@kernel.org, dianders@chromium.org,
linux-gpio@vger.kernel.org, nicolas.dechesne@linaro.org,
niklas.cassel@linaro.org, david.brown@linaro.org,
robh+dt@kernel.org, mark.rutland@arm.com,
thierry.reding@gmail.com, linux-arm-msm@vger.kernel.org,
linux-kernel@vger.kernel.org, devicetree@vger.kernel.org
Subject: [PATCH v2 07/11] arm: dts: qcom: apq8064: add interrupt controller properties
Date: Thu, 7 Feb 2019 21:16:27 -0500 [thread overview]
Message-ID: <20190208021631.30252-8-masneyb@onstation.org> (raw)
In-Reply-To: <20190208021631.30252-1-masneyb@onstation.org>
Add interrupt controller properties now that ssbi-gpio is a proper
hierarchical IRQ chip. The interrupts property is no longer needed so
remove it.
This change was not tested on any hardware but the same change was
tested on an APQ8060 DragonBoard with no issues.
Signed-off-by: Brian Masney <masneyb@onstation.org>
---
Changes since v1:
- None
arch/arm/boot/dts/qcom-apq8064.dtsi | 46 ++---------------------------
1 file changed, 2 insertions(+), 44 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-apq8064.dtsi b/arch/arm/boot/dts/qcom-apq8064.dtsi
index 1374c2e52c20..bd6907db615b 100644
--- a/arch/arm/boot/dts/qcom-apq8064.dtsi
+++ b/arch/arm/boot/dts/qcom-apq8064.dtsi
@@ -711,50 +711,8 @@
compatible = "qcom,pm8921-gpio",
"qcom,ssbi-gpio";
reg = <0x150>;
- interrupts = <192 IRQ_TYPE_NONE>,
- <193 IRQ_TYPE_NONE>,
- <194 IRQ_TYPE_NONE>,
- <195 IRQ_TYPE_NONE>,
- <196 IRQ_TYPE_NONE>,
- <197 IRQ_TYPE_NONE>,
- <198 IRQ_TYPE_NONE>,
- <199 IRQ_TYPE_NONE>,
- <200 IRQ_TYPE_NONE>,
- <201 IRQ_TYPE_NONE>,
- <202 IRQ_TYPE_NONE>,
- <203 IRQ_TYPE_NONE>,
- <204 IRQ_TYPE_NONE>,
- <205 IRQ_TYPE_NONE>,
- <206 IRQ_TYPE_NONE>,
- <207 IRQ_TYPE_NONE>,
- <208 IRQ_TYPE_NONE>,
- <209 IRQ_TYPE_NONE>,
- <210 IRQ_TYPE_NONE>,
- <211 IRQ_TYPE_NONE>,
- <212 IRQ_TYPE_NONE>,
- <213 IRQ_TYPE_NONE>,
- <214 IRQ_TYPE_NONE>,
- <215 IRQ_TYPE_NONE>,
- <216 IRQ_TYPE_NONE>,
- <217 IRQ_TYPE_NONE>,
- <218 IRQ_TYPE_NONE>,
- <219 IRQ_TYPE_NONE>,
- <220 IRQ_TYPE_NONE>,
- <221 IRQ_TYPE_NONE>,
- <222 IRQ_TYPE_NONE>,
- <223 IRQ_TYPE_NONE>,
- <224 IRQ_TYPE_NONE>,
- <225 IRQ_TYPE_NONE>,
- <226 IRQ_TYPE_NONE>,
- <227 IRQ_TYPE_NONE>,
- <228 IRQ_TYPE_NONE>,
- <229 IRQ_TYPE_NONE>,
- <230 IRQ_TYPE_NONE>,
- <231 IRQ_TYPE_NONE>,
- <232 IRQ_TYPE_NONE>,
- <233 IRQ_TYPE_NONE>,
- <234 IRQ_TYPE_NONE>,
- <235 IRQ_TYPE_NONE>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
gpio-controller;
#gpio-cells = <2>;
--
2.17.2
next prev parent reply other threads:[~2019-02-08 2:17 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-02-08 2:16 [PATCH v2 00/11] qcom: ssbi-gpio: add support for hierarchical IRQ chip Brian Masney
2019-02-08 2:16 ` [PATCH v2 01/11] pinctrl: qcom: ssbi-gpio: hardcode IRQ counts Brian Masney
2019-02-08 2:16 ` [PATCH v2 02/11] genirq: introduce irq_domain_translate_twocell Brian Masney
2019-02-08 13:25 ` Marc Zyngier
2019-02-08 2:16 ` [PATCH v2 03/11] genirq: introduce irq_chip_mask_ack_parent() Brian Masney
2019-02-08 2:16 ` [PATCH v2 04/11] mfd: pm8xxx: convert to v2 irq interfaces to support hierarchical IRQ chips Brian Masney
2019-02-12 8:38 ` Lee Jones
2019-02-08 2:16 ` [PATCH v2 05/11] mfd: pm8xxx: disassociate old virq if hwirq mapping already exists Brian Masney
2019-02-12 8:39 ` Lee Jones
2019-02-15 5:51 ` Stephen Boyd
2019-02-15 13:47 ` Brian Masney
2019-02-15 21:28 ` Stephen Boyd
2019-02-16 0:23 ` Brian Masney
2019-02-21 18:47 ` Stephen Boyd
2019-02-22 8:57 ` Marc Zyngier
2019-02-22 9:07 ` Linus Walleij
2019-02-08 2:16 ` [PATCH v2 06/11] qcom: ssbi-gpio: add support for hierarchical IRQ chip Brian Masney
2019-02-08 2:16 ` Brian Masney [this message]
2019-02-08 2:16 ` [PATCH v2 08/11] arm: dts: qcom: msm8660: add interrupt controller properties Brian Masney
2019-02-08 2:16 ` [PATCH v2 09/11] arm: dts: qcom: mdm9615: " Brian Masney
2019-02-08 2:16 ` [PATCH v2 10/11] ARM: dts: qcom-apq8060: Fix up interrupt parents Brian Masney
2019-02-08 2:16 ` [PATCH v2 11/11] mfd: pm8xxx: revert "disassociate old virq if hwirq mapping already exists" Brian Masney
2019-02-12 8:20 ` Lee Jones
2019-02-11 13:33 ` [PATCH v2 00/11] qcom: ssbi-gpio: add support for hierarchical IRQ chip Linus Walleij
2019-02-13 8:38 ` Linus Walleij
2019-02-21 11:59 ` Linus Walleij
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190208021631.30252-8-masneyb@onstation.org \
--to=masneyb@onstation.org \
--cc=andy.gross@linaro.org \
--cc=bjorn.andersson@linaro.org \
--cc=david.brown@linaro.org \
--cc=devicetree@vger.kernel.org \
--cc=dianders@chromium.org \
--cc=lee.jones@linaro.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=marc.zyngier@arm.com \
--cc=mark.rutland@arm.com \
--cc=nicolas.dechesne@linaro.org \
--cc=niklas.cassel@linaro.org \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
--cc=shawnguo@kernel.org \
--cc=tglx@linutronix.de \
--cc=thierry.reding@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).