On Thu, Apr 18, 2019 at 12:11:20PM -0300, Pablo Greco wrote:
> Since the bananapi-m2-ultra and the bananapi-m2-berry have the same
> WiFi/Bluetooth, add the required nodes to the bananapi-m2-berry.
>
> Signed-off-by: Pablo Greco <pgreco@centosproject.org>
> ---
>  arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts | 26 +++++++++++++++++++++++
>  1 file changed, 26 insertions(+)
>
> diff --git a/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts b/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts
> index 78f4a1a..3d0bb7e 100644
> --- a/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts
> +++ b/arch/arm/boot/dts/sun8i-v40-bananapi-m2-berry.dts
> @@ -96,6 +96,8 @@
>  	wifi_pwrseq: wifi_pwrseq {
>  		compatible = "mmc-pwrseq-simple";
>  		reset-gpios = <&pio 6 10 GPIO_ACTIVE_LOW>; /* PG10 WIFI_EN */
> +		clocks = <&ccu CLK_OUTA>;
> +		clock-names = "ext_clock";
>  	};
>  };
>
> @@ -171,6 +173,11 @@
>  	status = "okay";
>  };
>
> +&pio {
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&clk_out_a_pin>;
> +};
> +

I'm not sure you answered my question about why that is needed?

Maxime

--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com