From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: linux-kernel@vger.kernel.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
stable@vger.kernel.org, Hans Verkuil <hans.verkuil@cisco.com>,
Mauro Carvalho Chehab <mchehab@s-opensource.com>,
Naresh Kamboju <naresh.kamboju@linaro.org>
Subject: [PATCH 4.9 03/32] media: vivid: check if the cec_adapter is valid
Date: Thu, 2 May 2019 17:20:49 +0200 [thread overview]
Message-ID: <20190502143316.137488919@linuxfoundation.org> (raw)
In-Reply-To: <20190502143314.649935114@linuxfoundation.org>
From: Hans Verkuil <hverkuil@xs4all.nl>
commit ed356f110403f6acc64dcbbbfdc38662ab9b06c2 upstream.
If CEC is not enabled for the vivid driver, then the adap pointer is NULL
and 'adap->phys_addr' will fail.
Cc: <stable@vger.kernel.org> # for v4.12 and up
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>
[ Naresh: Fixed rebase conflict ]
Signed-off-by: Naresh Kamboju <naresh.kamboju@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/media/platform/vivid/vivid-vid-common.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
--- a/drivers/media/platform/vivid/vivid-vid-common.c
+++ b/drivers/media/platform/vivid/vivid-vid-common.c
@@ -841,6 +841,7 @@ int vidioc_g_edid(struct file *file, voi
if (edid->start_block + edid->blocks > dev->edid_blocks)
edid->blocks = dev->edid_blocks - edid->start_block;
memcpy(edid->edid, dev->edid, edid->blocks * 128);
- cec_set_edid_phys_addr(edid->edid, edid->blocks * 128, adap->phys_addr);
+ if (adap)
+ cec_set_edid_phys_addr(edid->edid, edid->blocks * 128, adap->phys_addr);
return 0;
}
next prev parent reply other threads:[~2019-05-02 15:22 UTC|newest]
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-05-02 15:20 [PATCH 4.9 00/32] 4.9.173-stable review Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 01/32] usbnet: ipheth: prevent TX queue timeouts when device not ready Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 02/32] usbnet: ipheth: fix potential null pointer dereference in ipheth_carrier_set Greg Kroah-Hartman
2019-05-02 15:20 ` Greg Kroah-Hartman [this message]
2019-05-02 15:20 ` [PATCH 4.9 04/32] ARM: dts: bcm283x: Fix hdmi hpd gpio pull Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 05/32] s390: limit brk randomization to 32MB Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 06/32] qlcnic: Avoid potential NULL pointer dereference Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 07/32] netfilter: nft_set_rbtree: check for inactive element after flag mismatch Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 08/32] netfilter: bridge: set skb transport_header before entering NF_INET_PRE_ROUTING Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 09/32] sc16is7xx: missing unregister/delete driver on error in sc16is7xx_init() Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 10/32] serial: ar933x_uart: Fix build failure with disabled console Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 11/32] usb: gadget: net2280: Fix overrun of OUT messages Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 12/32] usb: gadget: net2280: Fix net2280_dequeue() Greg Kroah-Hartman
2019-05-02 15:20 ` [PATCH 4.9 13/32] usb: gadget: net2272: Fix net2272_dequeue() Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 14/32] ARM: dts: pfla02: increase phy reset duration Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 15/32] net: ks8851: Dequeue RX packets explicitly Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 16/32] net: ks8851: Reassert reset pin if chip ID check fails Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 17/32] net: ks8851: Delay requesting IRQ until opened Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 18/32] net: ks8851: Set initial carrier state to down Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 19/32] staging: rtl8712: uninitialized memory in read_bbreg_hdl() Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 20/32] NFS: Fix a typo in nfs_init_timeout_values() Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 21/32] net: xilinx: fix possible object reference leak Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 22/32] net: ibm: " Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 23/32] net: ethernet: ti: " Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 24/32] scsi: qla4xxx: fix a potential NULL pointer dereference Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 25/32] usb: u132-hcd: fix resource leak Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 26/32] ceph: fix use-after-free on symlink traversal Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 27/32] scsi: zfcp: reduce flood of fcrscn1 trace records on multi-element RSCN Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 28/32] libata: fix using DMA buffers on stack Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 29/32] gpio: of: Fix of_gpiochip_add() error path Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 30/32] kconfig/[mn]conf: handle backspace (^H) key Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 31/32] leds: pca9532: fix a potential NULL pointer dereference Greg Kroah-Hartman
2019-05-02 15:21 ` [PATCH 4.9 32/32] vfio/type1: Limit DMA mappings per container Greg Kroah-Hartman
2019-05-02 23:06 ` [PATCH 4.9 00/32] 4.9.173-stable review kernelci.org bot
2019-05-03 7:04 ` Naresh Kamboju
2019-05-03 9:27 ` Jon Hunter
2019-05-03 17:15 ` Guenter Roeck
2019-05-03 21:21 ` shuah
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190502143316.137488919@linuxfoundation.org \
--to=gregkh@linuxfoundation.org \
--cc=hans.verkuil@cisco.com \
--cc=linux-kernel@vger.kernel.org \
--cc=mchehab@s-opensource.com \
--cc=naresh.kamboju@linaro.org \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).