[PATCH 1/5] dt-bindings: drm/bridge/synopsys: dw-hdmi: Add "unwedge" for ddc bus

[Douglas Anderson <dianders@chromium.org>]

In certain situations it was seen that we could wedge up the DDC bus
on the HDMI adapter on rk3288.  The only way to unwedge was to mux one
of the pins over to GPIO output-driven-low temporarily and then
quickly mux back.  Full details can be found in the patch
("drm/bridge/synopsys: dw-hdmi: Add "unwedge" for ddc bus").

Since unwedge requires remuxing the pins, we first need to add to the
bindings so that we can specify what state the pins should be in for
unwedging.

Signed-off-by: Douglas Anderson <dianders@chromium.org>
---

 .../bindings/display/rockchip/dw_hdmi-rockchip.txt         | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/Documentation/devicetree/bindings/display/rockchip/dw_hdmi-rockchip.txt b/Documentation/devicetree/bindings/display/rockchip/dw_hdmi-rockchip.txt
index 39143424a474..8346bac81f1c 100644
--- a/Documentation/devicetree/bindings/display/rockchip/dw_hdmi-rockchip.txt
+++ b/Documentation/devicetree/bindings/display/rockchip/dw_hdmi-rockchip.txt
@@ -38,6 +38,13 @@ Optional properties
 - phys: from general PHY binding: the phandle for the PHY device.
 - phy-names: Should be "hdmi" if phys references an external phy.
 
+Optional pinctrl entry:
+- If you have both a "unwedge" and "default" pinctrl entry, dw_hdmi
+  will switch to the unwedge pinctrl state for 10ms if it ever gets an
+  i2c timeout.  It's intended that this unwedge pinctrl entry will
+  cause the SDA line to be driven low to work around a hardware
+  errata.
+
 Example:
 
 hdmi: hdmi@ff980000 {
-- 
2.21.0.1020.gf2820cf01a-goog