[PATCH 4.14 15/69] net: mvpp2: fix bad MVPP2_TXQ_SCHED_TOKEN_CNTR_REG queue value

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

From: Antoine Tenart <antoine.tenart@bootlin.com>

[ Upstream commit 21808437214637952b61beaba6034d97880fbeb3 ]

MVPP2_TXQ_SCHED_TOKEN_CNTR_REG() expects the logical queue id but
the current code is passing the global tx queue offset, so it ends
up writing to unknown registers (between 0x8280 and 0x82fc, which
seemed to be unused by the hardware). This fixes the issue by using
the logical queue id instead.

Fixes: 3f518509dedc ("ethernet: Add new driver for Marvell Armada 375 network unit")
Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
 drivers/net/ethernet/marvell/mvpp2.c |   10 ++++------
 1 file changed, 4 insertions(+), 6 deletions(-)

--- a/drivers/net/ethernet/marvell/mvpp2.c
+++ b/drivers/net/ethernet/marvell/mvpp2.c
@@ -4780,7 +4780,7 @@ static inline void mvpp2_xlg_max_rx_size
 /* Set defaults to the MVPP2 port */
 static void mvpp2_defaults_set(struct mvpp2_port *port)
 {
-	int tx_port_num, val, queue, ptxq, lrxq;
+	int tx_port_num, val, queue, lrxq;
 
 	if (port->priv->hw_version == MVPP21) {
 		/* Configure port to loopback if needed */
@@ -4802,11 +4802,9 @@ static void mvpp2_defaults_set(struct mv
 	mvpp2_write(port->priv, MVPP2_TXP_SCHED_CMD_1_REG, 0);
 
 	/* Close bandwidth for all queues */
-	for (queue = 0; queue < MVPP2_MAX_TXQ; queue++) {
-		ptxq = mvpp2_txq_phys(port->id, queue);
+	for (queue = 0; queue < MVPP2_MAX_TXQ; queue++)
 		mvpp2_write(port->priv,
-			    MVPP2_TXQ_SCHED_TOKEN_CNTR_REG(ptxq), 0);
-	}
+			    MVPP2_TXQ_SCHED_TOKEN_CNTR_REG(queue), 0);
 
 	/* Set refill period to 1 usec, refill tokens
 	 * and bucket size to maximum
@@ -5645,7 +5643,7 @@ static void mvpp2_txq_deinit(struct mvpp
 	txq->descs_dma         = 0;
 
 	/* Set minimum bandwidth for disabled TXQs */
-	mvpp2_write(port->priv, MVPP2_TXQ_SCHED_TOKEN_CNTR_REG(txq->id), 0);
+	mvpp2_write(port->priv, MVPP2_TXQ_SCHED_TOKEN_CNTR_REG(txq->log_id), 0);
 
 	/* Set Tx descriptors queue starting address and size */
 	cpu = get_cpu();