[PATCH] ARM: dts: sun8i: a83t: Enable HDMI output on Cubietruck Plus

* [PATCH] ARM: dts: sun8i: a83t: Enable HDMI output on Cubietruck Plus
@ 2019-07-28 14:59 Chen-Yu Tsai
  2019-08-07  6:06 ` Chen-Yu Tsai
  0 siblings, 1 reply; 2+ messages in thread
From: Chen-Yu Tsai @ 2019-07-28 14:59 UTC (permalink / raw)
  To: Maxime Ripard; +Cc: Chen-Yu Tsai, devicetree, linux-arm-kernel, linux-kernel

From: Chen-Yu Tsai <wens@csie.org>

The Cubietruck Plus has an HDMI connector tied to the HDMI output of the
SoC.

Enables display output via HDMI on the Cubietruck Plus. The connector
device node is named "hdmi-connector" as there is also a display port
connector, which is tied to the MIPI DSI output of the SoC through a
MIPI-DSI-to-DP bridge. This part is not supported yet.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
 .../boot/dts/sun8i-a83t-cubietruck-plus.dts   | 25 +++++++++++++++++++
 1 file changed, 25 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts b/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts
index ea299d3d84d0..fb928503ad45 100644
--- a/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts
+++ b/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts
@@ -60,6 +60,17 @@
 		stdout-path = "serial0:115200n8";
 	};
 
+	hdmi-connector {
+		compatible = "hdmi-connector";
+		type = "a";
+
+		port {
+			hdmi_con_in: endpoint {
+				remote-endpoint = <&hdmi_out_con>;
+			};
+		};
+	};
+
 	leds {
 		compatible = "gpio-leds";
 
@@ -153,6 +164,10 @@
 	cpu-supply = <&reg_dcdc3>;
 };
 
+&de {
+	status = "okay";
+};
+
 &ehci0 {
 	/* GL830 USB-to-SATA bridge here */
 	status = "okay";
@@ -172,6 +187,16 @@
 	status = "okay";
 };
 
+&hdmi {
+	status = "okay";
+};
+
+&hdmi_out {
+	hdmi_out_con: endpoint {
+		remote-endpoint = <&hdmi_con_in>;
+	};
+};
+
 &mdio {
 	rgmii_phy: ethernet-phy@1 {
 		compatible = "ethernet-phy-ieee802.3-c22";
-- 
2.20.1


^ permalink raw reply related	[flat|nested] 2+ messages in thread