On Mon, Nov 18, 2019 at 08:53:57AM +0200, Matti Vaittinen wrote:

> +#Supported default DVS states:
> +#buck		| run		| idle		| suspend	| lpsr
> +#----------------------------------------------------------------------------
> +#1, 2, 6, and 7	| supported	| supported	| 	supported (*)
> +#----------------------------------------------------------------------------
> +#3, 4, and 5	| 			supported (**)
> +#----------------------------------------------------------------------------
> +#(*)  LPSR and SUSPEND states use same voltage but both states have own enable /
> +#     disable settings. Voltage 0 can be specified for a state to make regulator
> +#     disabled on that state.
> +#(**) All states use same voltage but have own enable / disable settings.
> +#     Voltage 0 can be specified for a state to make regulator disabled on that
> +#     state.
> +
> +      rohm,dvs-runlvl-ctrl:
> +        description: |
> +          buck control is done based on run-level. Regulator is not
> +          individually controllable. See ../mfd/rohm,bd71828-pmic.yaml for
> +          how to specify run-level control mechanism. Only bucks 1, 2, 6
> +          and 7 support this.
> +        type: boolean

I don't think I saw this having the effect on set_voltage() that I'd
have expected in the driver?  

> +      rohm,dvs-runlevel-microvolts:
> +        minimum: 0
> +        maximum: 2000000
> +        maxItems: 4
> +        description:
> +          Array of voltages for run-levels. First value is for run-level 0,
> +          second for run-level 1 etc. Microvolts.

What's the mapping from array indexes to the names used elsewhere to
support runlevels?