On Wed, Feb 12, 2020 at 02:11:31PM +0800, JC Kuo wrote:
> Extend the bindings to cover the set of features found in Tegra194.
> Note that, technically, there are four more supplies connected to the
> XUSB pad controller (DVDD_PEX, DVDD_PEX_PLL, HVDD_PEX and HVDD_PEX_PLL)
> , but the power sequencing requirements of Tegra194 require these to be
> under the control of the PMIC.
> 
> Tegra194 XUSB PADCTL supports up to USB 3.1 Gen 2 speed, however, it
> is possible for some platforms have long signal trace that could not
> provide sufficient electrical environment for Gen 2 speed. This patch
> adds a "maximum-speed" property to usb3 ports which can be used to
> specify the maximum supported speed for any particular USB 3.1 port.
> For a port that is not capable of SuperSpeedPlus, "maximum-speed"
> property should carry "super-speed".
> 
> Signed-off-by: JC Kuo <jckuo@nvidia.com>
> ---
> Changes in v6: none
> Changes in v5:
> - re-use "maximum-speed" instead of adding "nvidia,disable-gen2"
> Changes in v4: none
> Changes in v3: none
> Changes in v2:
> - fix a typo
> 
>  .../phy/nvidia,tegra124-xusb-padctl.txt        | 18 ++++++++++++++++++
>  1 file changed, 18 insertions(+)

Acked-by: Thierry Reding <treding@nvidia.com>