[PATCH v2 4/4] USB: pci-quirks: Add Raspberry Pi 4 quirk

[Nicolas Saenz Julienne <nsaenzjulienne@suse.de>]

On the Raspberry Pi 4, after a PCI reset, VL805's firmware may either be
loaded directly from an EEPROM or, if not present, by the SoC's
VideCore. Inform VideCore that VL805 was just reset.

Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de>
---
 drivers/usb/host/pci-quirks.c | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/drivers/usb/host/pci-quirks.c b/drivers/usb/host/pci-quirks.c
index beb2efa71341..aee2eaa3f0e1 100644
--- a/drivers/usb/host/pci-quirks.c
+++ b/drivers/usb/host/pci-quirks.c
@@ -16,6 +16,9 @@
 #include <linux/export.h>
 #include <linux/acpi.h>
 #include <linux/dmi.h>
+
+#include <soc/bcm2835/raspberrypi-firmware.h>
+
 #include "pci-quirks.h"
 #include "xhci-ext-caps.h"
 
@@ -1243,11 +1246,26 @@ static void quirk_usb_handoff_xhci(struct pci_dev *pdev)
 
 static void quirk_usb_early_handoff(struct pci_dev *pdev)
 {
+	int ret;
+
 	/* Skip Netlogic mips SoC's internal PCI USB controller.
 	 * This device does not need/support EHCI/OHCI handoff
 	 */
 	if (pdev->vendor == 0x184e)	/* vendor Netlogic */
 		return;
+
+	if (pdev->vendor == PCI_VENDOR_ID_VIA && pdev->device == 0x3483) {
+		ret = rpi_firmware_init_vl805(pdev);
+		if (ret)
+			/*
+			 * Firmware might be outdated, or else, something
+			 * failed, keep going and hope for the best.
+			 */
+			dev_warn(&pdev->dev,
+				 "Failed to load VL805's firmware: %d\n",
+				 ret);
+	}
+
 	if (pdev->class != PCI_CLASS_SERIAL_USB_UHCI &&
 			pdev->class != PCI_CLASS_SERIAL_USB_OHCI &&
 			pdev->class != PCI_CLASS_SERIAL_USB_EHCI &&
-- 
2.25.0