Hi Alain,

On Thu, Mar 26, 2020 at 01:44:21PM +0100, Alain Volmat wrote:
> Do not limitate to the 3 (100KHz, 400KHz, 1MHz) bus frequency but
> instead allows any frequency (if it matches timing requirements).
> Depending on the requested frequency, use the spec data from either
> Standard, Fast or Fast Plus mode.
> 
> Hardcoding of min/max bus frequencies is removed and is instead computed.
> 
> The driver do not use anymore speed identifier but instead handle
> directly the frequency and figure out the spec data (necessary
> for the computation of the timing register) based on the frequency.

Useful improvement!

> +static struct stm32f7_i2c_spec *get_specs(u32 rate)

This is quite a generic namespace. Can we prefix stm32f7_<sth> here?

> +		if (rate <= i2c_specs[i].rate)
> +			return &i2c_specs[i];

Same for i2c_specs here?

> +static u32 get_lower_rate(u32 rate)

Here, too.

Rest looks good to me.

Regards,

   Wolfram