[PATCH] tty: mxser: make mxser_change_speed() return void

[PATCH] tty: mxser: make mxser_change_speed() return void

[Jason Yan]

No other functions use the return value of mxser_change_speed() and the
return value is always 0 now. Make it return void. This fixes the
following coccicheck warning:

drivers/tty/mxser.c:645:5-8: Unneeded variable: "ret". Return "0" on
line 650

Signed-off-by: Jason Yan <yanaijie@huawei.com>
---
 drivers/tty/mxser.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)

diff --git a/drivers/tty/mxser.c b/drivers/tty/mxser.c
index 9d00ff5ef961..3703987c4666 100644
--- a/drivers/tty/mxser.c
+++ b/drivers/tty/mxser.c
@@ -638,16 +638,15 @@ static int mxser_set_baud(struct tty_struct *tty, long newspd)
  * This routine is called to set the UART divisor registers to match
  * the specified baud rate for a serial port.
  */
-static int mxser_change_speed(struct tty_struct *tty)
+static void mxser_change_speed(struct tty_struct *tty)
 {
 	struct mxser_port *info = tty->driver_data;
 	unsigned cflag, cval, fcr;
-	int ret = 0;
 	unsigned char status;
 
 	cflag = tty->termios.c_cflag;
 	if (!info->ioaddr)
-		return ret;
+		return;
 
 	if (mxser_set_baud_method[tty->index] == 0)
 		mxser_set_baud(tty, tty_get_baud_rate(tty));
@@ -803,8 +802,6 @@ static int mxser_change_speed(struct tty_struct *tty)
 
 	outb(fcr, info->ioaddr + UART_FCR);	/* set fcr */
 	outb(cval, info->ioaddr + UART_LCR);
-
-	return ret;
 }
 
 static void mxser_check_modem_status(struct tty_struct *tty,
-- 
2.21.1