On Fri, Jun 05, 2020 at 08:37:24AM +0200, Marek Szyprowski wrote: > Balancing of the 'boot-on' coupled regulators must wait until the clients > set their constraints, otherwise the balancing code might change the No, this is not what boot-on means at all. It is there for cases where we can't read the enable status from the hardware. Trying to infer *anything* about the runtime behaviour from it being present or absent is very badly broken. Saravana (CCed) was working on some patches which tried to deal with some stuff around this for enables using the sync_state() callback. Unfortunately there's quite a few problems with the current approach (the biggest one from my point of view being that it's implemented so that it requires every single consumer of every device on the PMIC to come up but there's others at more of an implementation level).