Hi,

On Wed, Jun 17, 2020 at 12:23:05PM +0200, Krzysztof Kozlowski wrote:
> The driver requires interrupts (fails probe if it is not provided) so
> document this requirement in bindings.
> 
> Fixes: 4aeae9cb0dad ("power_supply: Add support for TI BQ25890 charger chip")
> Cc: <stable@vger.kernel.org>
> Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
> ---

Thanks, queued.

-- Sebastian

>  Documentation/devicetree/bindings/power/supply/bq25890.txt | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/power/supply/bq25890.txt b/Documentation/devicetree/bindings/power/supply/bq25890.txt
> index 51ecc756521f..3b4c69a7fa70 100644
> --- a/Documentation/devicetree/bindings/power/supply/bq25890.txt
> +++ b/Documentation/devicetree/bindings/power/supply/bq25890.txt
> @@ -10,6 +10,7 @@ Required properties:
>      * "ti,bq25895"
>      * "ti,bq25896"
>  - reg: integer, i2c address of the device.
> +- interrupts: interrupt line;
>  - ti,battery-regulation-voltage: integer, maximum charging voltage (in uV);
>  - ti,charge-current: integer, maximum charging current (in uA);
>  - ti,termination-current: integer, charge will be terminated when current in
> @@ -39,6 +40,9 @@ bq25890 {
>  	compatible = "ti,bq25890";
>  	reg = <0x6a>;
>  
> +	interrupt-parent = <&gpio1>;
> +	interrupts = <16 IRQ_TYPE_EDGE_FALLING>;
> +
>  	ti,battery-regulation-voltage = <4200000>;
>  	ti,charge-current = <1000000>;
>  	ti,termination-current = <50000>;
> -- 
> 2.17.1
>