On Wed, Sep 09, 2020 at 01:40:01AM +0300, Dmitry Osipenko wrote:
> Reorder definition of variables in the code to have them sorted by length
> and grouped logically, also replace "unsigned long" with "u32". Do this in
> order to make code easier to read.
> 
> Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
> ---
>  drivers/i2c/busses/i2c-tegra.c | 97 ++++++++++++++++------------------
>  1 file changed, 45 insertions(+), 52 deletions(-)
> 
> diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
> index ac40c87f1c21..2376f502d299 100644
> --- a/drivers/i2c/busses/i2c-tegra.c
> +++ b/drivers/i2c/busses/i2c-tegra.c
> @@ -259,42 +259,48 @@ struct tegra_i2c_hw_feature {
>   */
>  struct tegra_i2c_dev {
>  	struct device *dev;
> -	const struct tegra_i2c_hw_feature *hw;
>  	struct i2c_adapter adapter;
> -	struct clk *div_clk;
> -	struct clk_bulk_data *clocks;
> -	unsigned int nclocks;
> +
> +	const struct tegra_i2c_hw_feature *hw;
>  	struct reset_control *rst;
> -	void __iomem *base;
> -	phys_addr_t base_phys;
>  	unsigned int cont_id;
>  	unsigned int irq;
> -	bool is_dvc;
> -	bool is_vi;
> +
> +	phys_addr_t base_phys;
> +	void __iomem *base;
> +
> +	struct clk_bulk_data *clocks;
> +	unsigned int nclocks;
> +
> +	struct clk *div_clk;
> +	u32 bus_clk_rate;
> +
>  	struct completion msg_complete;
> +	size_t msg_buf_remaining;
>  	int msg_err;
>  	u8 *msg_buf;
> -	size_t msg_buf_remaining;
> -	bool msg_read;
> -	u32 bus_clk_rate;
> -	bool is_multimaster_mode;
> +
> +	struct completion dma_complete;
>  	struct dma_chan *tx_dma_chan;
>  	struct dma_chan *rx_dma_chan;
> +	unsigned int dma_buf_size;
>  	dma_addr_t dma_phys;
>  	u32 *dma_buf;
> -	unsigned int dma_buf_size;
> -	bool is_curr_dma_xfer;
> -	struct completion dma_complete;
> +
> +	bool is_multimaster_mode;
>  	bool is_curr_atomic_xfer;
> +	bool is_curr_dma_xfer;
> +	bool msg_read;
> +	bool is_dvc;
> +	bool is_vi;
>  };
>  
> -static void dvc_writel(struct tegra_i2c_dev *i2c_dev, u32 val,
> -		       unsigned long reg)
> +static void dvc_writel(struct tegra_i2c_dev *i2c_dev, u32 val, u32 reg)

I actually prefer unsigned long/int over u32 for offsets because it
makes it clearer that this is not in fact a 32-bit value that we're
writing into a register. This is especially true for these register
accessors where the "offset" is called "reg" and may be easily
mistaken for a register value.

Thierry