From: Pratyush Yadav <p.yadav@ti.com>
To: Tudor Ambarus <tudor.ambarus@microchip.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Richard Weinberger <richard@nod.at>,
Vignesh Raghavendra <vigneshr@ti.com>,
<linux-mtd@lists.infradead.org>, <linux-kernel@vger.kernel.org>
Cc: Pratyush Yadav <p.yadav@ti.com>, Sekhar Nori <nsekhar@ti.com>,
Boris Brezillon <boris.brezillon@collabora.com>
Subject: [PATCH v16 10/15] mtd: spi-nor: core: enable octal DTR mode when possible
Date: Mon, 5 Oct 2020 21:01:33 +0530 [thread overview]
Message-ID: <20201005153138.6437-11-p.yadav@ti.com> (raw)
In-Reply-To: <20201005153138.6437-1-p.yadav@ti.com>
Allow flashes to specify a hook to enable octal DTR mode. Use this hook
whenever possible to get optimal transfer speeds.
Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
Reviewed-by: Tudor Ambarus <tudor.ambarus@microchip.com>
---
drivers/mtd/spi-nor/core.c | 38 ++++++++++++++++++++++++++++++++++++++
drivers/mtd/spi-nor/core.h | 2 ++
2 files changed, 40 insertions(+)
diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
index e91ddb409699..cf6ada7c8a7b 100644
--- a/drivers/mtd/spi-nor/core.c
+++ b/drivers/mtd/spi-nor/core.c
@@ -3068,6 +3068,38 @@ static int spi_nor_init_params(struct spi_nor *nor)
return 0;
}
+/** spi_nor_octal_dtr_enable() - enable Octal DTR I/O if needed
+ * @nor: pointer to a 'struct spi_nor'
+ * @enable: whether to enable or disable Octal DTR
+ *
+ * Return: 0 on success, -errno otherwise.
+ */
+static int spi_nor_octal_dtr_enable(struct spi_nor *nor, bool enable)
+{
+ int ret;
+
+ if (!nor->params->octal_dtr_enable)
+ return 0;
+
+ if (!(nor->read_proto == SNOR_PROTO_8_8_8_DTR &&
+ nor->write_proto == SNOR_PROTO_8_8_8_DTR))
+ return 0;
+
+ if (!(nor->flags & SNOR_F_IO_MODE_EN_VOLATILE))
+ return 0;
+
+ ret = nor->params->octal_dtr_enable(nor, enable);
+ if (ret)
+ return ret;
+
+ if (enable)
+ nor->reg_proto = SNOR_PROTO_8_8_8_DTR;
+ else
+ nor->reg_proto = SNOR_PROTO_1_1_1;
+
+ return 0;
+}
+
/**
* spi_nor_quad_enable() - enable Quad I/O if needed.
* @nor: pointer to a 'struct spi_nor'
@@ -3107,6 +3139,12 @@ static int spi_nor_init(struct spi_nor *nor)
{
int err;
+ err = spi_nor_octal_dtr_enable(nor, true);
+ if (err) {
+ dev_dbg(nor->dev, "octal mode not supported\n");
+ return err;
+ }
+
err = spi_nor_quad_enable(nor);
if (err) {
dev_dbg(nor->dev, "quad mode not supported\n");
diff --git a/drivers/mtd/spi-nor/core.h b/drivers/mtd/spi-nor/core.h
index eaece1123c0b..105a4ddeb309 100644
--- a/drivers/mtd/spi-nor/core.h
+++ b/drivers/mtd/spi-nor/core.h
@@ -204,6 +204,7 @@ struct spi_nor_locking_ops {
* higher index in the array, the higher priority.
* @erase_map: the erase map parsed from the SFDP Sector Map Parameter
* Table.
+ * @octal_dtr_enable: enables SPI NOR octal DTR mode.
* @quad_enable: enables SPI NOR quad mode.
* @set_4byte_addr_mode: puts the SPI NOR in 4 byte addressing mode.
* @convert_addr: converts an absolute address into something the flash
@@ -227,6 +228,7 @@ struct spi_nor_flash_parameter {
struct spi_nor_erase_map erase_map;
+ int (*octal_dtr_enable)(struct spi_nor *nor, bool enable);
int (*quad_enable)(struct spi_nor *nor);
int (*set_4byte_addr_mode)(struct spi_nor *nor, bool enable);
u32 (*convert_addr)(struct spi_nor *nor, u32 addr);
--
2.28.0
next prev parent reply other threads:[~2020-10-05 15:36 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-10-05 15:31 [PATCH v16 00/15] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 01/15] mtd: spi-nor: core: use EOPNOTSUPP instead of ENOTSUPP Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 02/15] mtd: spi-nor: add spi_nor_controller_ops_{read_reg,write_reg,erase}() Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 03/15] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 04/15] mtd: spi-nor: sfdp: get command opcode extension type from BFPT Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 05/15] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table Pratyush Yadav
2020-10-27 9:58 ` Tudor.Ambarus
2020-10-05 15:31 ` [PATCH v16 06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 07/15] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 08/15] mtd: spi-nor: Introduce SNOR_F_IO_MODE_EN_VOLATILE Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 09/15] mtd: spi-nor: Parse SFDP SCCR Map Pratyush Yadav
2020-10-05 15:31 ` Pratyush Yadav [this message]
2020-10-05 15:31 ` [PATCH v16 11/15] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 12/15] mtd: spi-nor: core: perform a Soft Reset on shutdown Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 13/15] mtd: spi-nor: core: disable Octal DTR mode on suspend Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 14/15] mtd: spi-nor: spansion: add support for Cypress Semper flash Pratyush Yadav
2020-11-07 7:58 ` Vignesh Raghavendra
2020-11-09 11:45 ` Pratyush Yadav
2020-11-09 13:28 ` Tudor.Ambarus
2020-10-05 15:31 ` [PATCH v16 15/15] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-10-06 8:11 ` Tudor.Ambarus
2020-10-28 7:53 ` [PATCH v16 00/15] mtd: spi-nor: add xSPI Octal DTR support Tudor.Ambarus
2020-10-28 12:49 ` Pratyush Yadav
2020-10-28 15:21 ` Tudor.Ambarus
2020-10-28 20:02 ` Pratyush Yadav
2020-10-29 6:26 ` Vignesh Raghavendra
2020-11-09 17:25 ` Vignesh Raghavendra
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20201005153138.6437-11-p.yadav@ti.com \
--to=p.yadav@ti.com \
--cc=boris.brezillon@collabora.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=nsekhar@ti.com \
--cc=richard@nod.at \
--cc=tudor.ambarus@microchip.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).