From: Hans de Goede <hdegoede@redhat.com>
To: Lee Jones <lee.jones@linaro.org>,
MyungJoo Ham <myungjoo.ham@samsung.com>,
Chanwoo Choi <cw00.choi@samsung.com>,
Cezary Rojewski <cezary.rojewski@intel.com>,
Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>,
Liam Girdwood <liam.r.girdwood@linux.intel.com>,
Jie Yang <yang.jie@linux.intel.com>,
Mark Brown <broonie@kernel.org>
Cc: Hans de Goede <hdegoede@redhat.com>,
patches@opensource.cirrus.com, linux-kernel@vger.kernel.org,
alsa-devel@alsa-project.org
Subject: [PATCH 06/14] extcon: arizona: Fix various races on driver unbind
Date: Sun, 27 Dec 2020 22:12:24 +0100 [thread overview]
Message-ID: <20201227211232.117801-7-hdegoede@redhat.com> (raw)
In-Reply-To: <20201227211232.117801-1-hdegoede@redhat.com>
We must free/disable all interrupts and cancel all pending works
before doing further cleanup.
Before this commit arizona_extcon_remove() was doing several
register writes to shut things down before disabling the IRQs
and it was cancelling only 1 of the 3 different works used.
Move all the register-writes shutting things down to after
the disabling of the IRQs and add the 2 missing
cancel_delayed_work_sync() calls.
This fixes various possible races on driver unbind. One of which
would always trigger on devices using the mic-clamp feature for
jack detection. The ARIZONA_MICD_CLAMP_MODE_MASK update was
done before disabling the IRQs, causing:
1. arizona_jackdet() to run
2. detect a jack being inserted (clamp disabled means jack inserted)
3. call arizona_start_mic() which:
3.1 Enables the MICVDD regulator
3.2 takes a pm_runtime_reference
And this was all happening after the ARIZONA_MICD_ENA bit clearing,
which would undo 3.1 and 3.2 because the ARIZONA_MICD_CLAMP_MODE_MASK
update was being done after the ARIZONA_MICD_ENA bit clearing.
So this means that arizona_extcon_remove() would exit with
1. MICVDD enabled and 2. The pm_runtime_reference being unbalanced.
MICVDD still being enabled caused the following oops when the
regulator is released by the devm framework:
[ 2850.745757] ------------[ cut here ]------------
[ 2850.745827] WARNING: CPU: 2 PID: 2098 at drivers/regulator/core.c:2123 _regulator_put.part.0+0x19f/0x1b0
[ 2850.745835] Modules linked in: extcon_arizona ...
...
[ 2850.746909] Call Trace:
[ 2850.746932] regulator_put+0x2d/0x40
[ 2850.746946] release_nodes+0x22a/0x260
[ 2850.746984] __device_release_driver+0x190/0x240
[ 2850.747002] driver_detach+0xd4/0x120
...
[ 2850.747337] ---[ end trace f455dfd7abd9781f ]---
Note this oops is just one of various theoretically possible races caused
by the wrong ordering inside arizona_extcon_remove(), this fixes the
ordering fixing all possible races, including the reported oops.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
---
drivers/extcon/extcon-arizona.c | 40 +++++++++++++++++----------------
1 file changed, 21 insertions(+), 19 deletions(-)
diff --git a/drivers/extcon/extcon-arizona.c b/drivers/extcon/extcon-arizona.c
index f7ef247de46a..76aacbac5869 100644
--- a/drivers/extcon/extcon-arizona.c
+++ b/drivers/extcon/extcon-arizona.c
@@ -1760,25 +1760,6 @@ static int arizona_extcon_remove(struct platform_device *pdev)
bool change;
int ret;
- ret = regmap_update_bits_check(arizona->regmap, ARIZONA_MIC_DETECT_1,
- ARIZONA_MICD_ENA, 0,
- &change);
- if (ret < 0) {
- dev_err(&pdev->dev, "Failed to disable micd on remove: %d\n",
- ret);
- } else if (change) {
- regulator_disable(info->micvdd);
- pm_runtime_put(info->dev);
- }
-
- gpiod_put(info->micd_pol_gpio);
-
- pm_runtime_disable(&pdev->dev);
-
- regmap_update_bits(arizona->regmap,
- ARIZONA_MICD_CLAMP_CONTROL,
- ARIZONA_MICD_CLAMP_MODE_MASK, 0);
-
if (info->micd_clamp) {
jack_irq_rise = ARIZONA_IRQ_MICD_CLAMP_RISE;
jack_irq_fall = ARIZONA_IRQ_MICD_CLAMP_FALL;
@@ -1794,10 +1775,31 @@ static int arizona_extcon_remove(struct platform_device *pdev)
arizona_free_irq(arizona, jack_irq_rise, info);
arizona_free_irq(arizona, jack_irq_fall, info);
cancel_delayed_work_sync(&info->hpdet_work);
+ cancel_delayed_work_sync(&info->micd_detect_work);
+ cancel_delayed_work_sync(&info->micd_timeout_work);
+
+ ret = regmap_update_bits_check(arizona->regmap, ARIZONA_MIC_DETECT_1,
+ ARIZONA_MICD_ENA, 0,
+ &change);
+ if (ret < 0) {
+ dev_err(&pdev->dev, "Failed to disable micd on remove: %d\n",
+ ret);
+ } else if (change) {
+ regulator_disable(info->micvdd);
+ pm_runtime_put(info->dev);
+ }
+
+ regmap_update_bits(arizona->regmap,
+ ARIZONA_MICD_CLAMP_CONTROL,
+ ARIZONA_MICD_CLAMP_MODE_MASK, 0);
regmap_update_bits(arizona->regmap, ARIZONA_JACK_DETECT_ANALOGUE,
ARIZONA_JD1_ENA, 0);
arizona_clk32k_disable(arizona);
+ gpiod_put(info->micd_pol_gpio);
+
+ pm_runtime_disable(&pdev->dev);
+
return 0;
}
--
2.28.0
next prev parent reply other threads:[~2020-12-27 21:14 UTC|newest]
Thread overview: 49+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-12-27 21:12 [PATCH 00/14] MFD/extcon/ASoC: Add support for Intel Bay Trail boards with WM5102 codec Hans de Goede
2020-12-27 21:12 ` [PATCH 01/14] mfd: arizona: Add jack pointer to struct arizona Hans de Goede
2020-12-28 12:21 ` Mark Brown
2020-12-28 13:16 ` Hans de Goede
2020-12-28 16:28 ` Mark Brown
2020-12-29 13:06 ` Charles Keepax
2020-12-29 13:57 ` Hans de Goede
2020-12-29 15:06 ` Charles Keepax
2020-12-29 15:15 ` Mark Brown
2020-12-29 15:40 ` Hans de Goede
2020-12-29 16:51 ` Richard Fitzgerald
2020-12-30 11:04 ` Hans de Goede
2020-12-30 11:23 ` Richard Fitzgerald
2020-12-30 12:01 ` Hans de Goede
2020-12-30 13:16 ` Mark Brown
2020-12-29 16:43 ` Richard Fitzgerald
2020-12-29 15:08 ` Mark Brown
2020-12-29 15:33 ` Hans de Goede
2020-12-30 13:38 ` Mark Brown
2021-01-01 13:24 ` Hans de Goede
2020-12-27 21:12 ` [PATCH 02/14] mfd: arizona: Add MODULE_SOFTDEP("pre: arizona_ldo1") Hans de Goede
2020-12-29 11:40 ` Charles Keepax
2020-12-27 21:12 ` [PATCH 03/14] mfd: arizona: Add support for ACPI enumeration of WM5102 connected over SPI Hans de Goede
2020-12-28 14:14 ` Andy Shevchenko
2021-01-16 14:46 ` Hans de Goede
2020-12-27 21:12 ` [PATCH 04/14] mfd: arizona: Allow building arizona MFD-core as module Hans de Goede
2020-12-29 12:00 ` Charles Keepax
2021-01-11 19:12 ` Hans de Goede
2020-12-27 21:12 ` [PATCH 05/14] extcon: arizona: Fix some issues when HPDET IRQ fires after the jack has been unplugged Hans de Goede
2020-12-27 21:12 ` Hans de Goede [this message]
2020-12-29 12:10 ` [PATCH 06/14] extcon: arizona: Fix various races on driver unbind Charles Keepax
2020-12-27 21:12 ` [PATCH 07/14] extcon: arizona: Fix modalias Hans de Goede
2020-12-29 12:10 ` Charles Keepax
2020-12-27 21:12 ` [PATCH 08/14] extcon: arizona: Fix flags parameter to the gpiod_get("wlf,micd-pol") call Hans de Goede
2020-12-29 12:12 ` Charles Keepax
2020-12-27 21:12 ` [PATCH 09/14] extcon: arizona: Add arizona_set_extcon_state() helper Hans de Goede
2020-12-29 12:57 ` Charles Keepax
2020-12-27 21:12 ` [PATCH 10/14] extcon: arizona: Also report jack state through snd_soc_jack_report() Hans de Goede
2020-12-28 14:16 ` Andy Shevchenko
2020-12-27 21:12 ` [PATCH 11/14] extcon: arizona: Use ASoC jack input-device when available Hans de Goede
2020-12-27 21:12 ` [PATCH 12/14] ASoC: Intel: Add DMI quirk table to soc_intel_is_byt_cr() Hans de Goede
2021-01-11 17:52 ` Pierre-Louis Bossart
2020-12-27 21:12 ` [PATCH 13/14] ASoC: Intel: bytcr_wm5102: Add machine driver for BYT/WM5102 Hans de Goede
2020-12-29 13:58 ` Charles Keepax
2021-01-11 17:54 ` Pierre-Louis Bossart
2021-01-16 16:49 ` Hans de Goede
2020-12-27 21:12 ` [PATCH 14/14] ASoC: Intel: bytcr_wm5102: Add jack detect support Hans de Goede
2020-12-28 14:19 ` [PATCH 00/14] MFD/extcon/ASoC: Add support for Intel Bay Trail boards with WM5102 codec Andy Shevchenko
2021-01-11 18:54 ` Hans de Goede
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20201227211232.117801-7-hdegoede@redhat.com \
--to=hdegoede@redhat.com \
--cc=alsa-devel@alsa-project.org \
--cc=broonie@kernel.org \
--cc=cezary.rojewski@intel.com \
--cc=cw00.choi@samsung.com \
--cc=lee.jones@linaro.org \
--cc=liam.r.girdwood@linux.intel.com \
--cc=linux-kernel@vger.kernel.org \
--cc=myungjoo.ham@samsung.com \
--cc=patches@opensource.cirrus.com \
--cc=pierre-louis.bossart@linux.intel.com \
--cc=yang.jie@linux.intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).