Hi,

On Wed, May 26, 2021 at 01:20:35PM -0400, Krzysztof Kozlowski wrote:
> From: Krzysztof Kozlowski <krzk@kernel.org>
> 
> Interrupt line can be configured on different hardware in different way,
> even inverted.  Therefore driver should not enforce specific trigger
> type - edge falling - but instead rely on Devicetree to configure it.
> 
> The Maxim 17047/77693 datasheets describe the interrupt line as active
> low with a requirement of acknowledge from the CPU therefore the edge
> falling is not correct.
> 
> The interrupt line is shared between PMIC and RTC driver, so using level
> sensitive interrupt is here especially important to avoid races.  With
> an edge configuration in case if first PMIC signals interrupt followed
> shortly after by the RTC, the interrupt might not be yet cleared/acked
> thus the second one would not be noticed.
> 
> Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
> 
> ---
> 
> Changes since v1:
> 1. None
> ---

Thanks, queued.

-- Sebastian

>  drivers/power/supply/max17042_battery.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/power/supply/max17042_battery.c b/drivers/power/supply/max17042_battery.c
> index 1d7326cd8fc6..ce2041b30a06 100644
> --- a/drivers/power/supply/max17042_battery.c
> +++ b/drivers/power/supply/max17042_battery.c
> @@ -1104,7 +1104,7 @@ static int max17042_probe(struct i2c_client *client,
>  	}
>  
>  	if (client->irq) {
> -		unsigned int flags = IRQF_TRIGGER_FALLING | IRQF_ONESHOT;
> +		unsigned int flags = IRQF_ONESHOT;
>  
>  		/*
>  		 * On ACPI systems the IRQ may be handled by ACPI-event code,
> -- 
> 2.27.0
>