[PATCH net-next v3 1/6] net: dsa: qca: ar9331: reorder MDIO write sequence

[Oleksij Rempel <o.rempel@pengutronix.de>]

In case of this switch we work with 32bit registers on top of 16bit
bus. Some registers (for example access to forwarding database) have
trigger bit on the first 16bit half of request and the result +
configuration of request in the second half. Without this patch, we would
trigger database operation and overwrite result in one run.

To make it work properly, we should do the second part of transfer
before the first one is done.

So far, this rule seems to work for all registers on this switch.

Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
---
 drivers/net/dsa/qca/ar9331.c | 14 +++++++++++---
 1 file changed, 11 insertions(+), 3 deletions(-)

diff --git a/drivers/net/dsa/qca/ar9331.c b/drivers/net/dsa/qca/ar9331.c
index ca2ad77b71f1..6686192e1883 100644
--- a/drivers/net/dsa/qca/ar9331.c
+++ b/drivers/net/dsa/qca/ar9331.c
@@ -837,16 +837,24 @@ static int ar9331_mdio_write(void *ctx, u32 reg, u32 val)
 		return 0;
 	}
 
-	ret = __ar9331_mdio_write(sbus, AR9331_SW_MDIO_PHY_MODE_REG, reg, val);
+	/* In case of this switch we work with 32bit registers on top of 16bit
+	 * bus. Some registers (for example access to forwarding database) have
+	 * trigger bit on the first 16bit half of request, the result and
+	 * configuration of request in the second half.
+	 * To make it work properly, we should do the second part of transfer
+	 * before the first one is done.
+	 */
+	ret = __ar9331_mdio_write(sbus, AR9331_SW_MDIO_PHY_MODE_REG, reg + 2,
+				  val >> 16);
 	if (ret < 0)
 		goto error;
 
-	ret = __ar9331_mdio_write(sbus, AR9331_SW_MDIO_PHY_MODE_REG, reg + 2,
-				  val >> 16);
+	ret = __ar9331_mdio_write(sbus, AR9331_SW_MDIO_PHY_MODE_REG, reg, val);
 	if (ret < 0)
 		goto error;
 
 	return 0;
+
 error:
 	dev_err_ratelimited(&sbus->dev, "Bus error. Failed to write register.\n");
 	return ret;
-- 
2.30.2