On Fri, Sep 17, 2021 at 04:15:36PM +0530, Satya Priya wrote:

> +    properties:
> +      reg:
> +        maxItems: 1
> +      regulator-name: true
> +      regulator-min-microvolt: true
> +      regulator-max-microvolt: true

You shouldn't be forcing these properties, it should be perfectly OK for
boards to have fixed voltages especially for example during bringup or
for debugging.

> +      qcom,min-dropout-voltage:
> +        $ref: /schemas/types.yaml#/definitions/uint32
> +        description:
> +          Specifies the minimum voltage in microvolts that the parent
> +          supply regulator must output, above the output of this
> +          regulator.

If this is needed in DT it should be a generic property since most
regulators have some requirement here however usually it's a fixed
property of the silicon and should therefore just gets set in the
regulator_desc as min_dropout_uV - I'd strongly recommend having a
default there even if there's some requirement for it to be set per
board.