Re: [net-next PATCH 14/19] net: dsa: qca8k: add support for mdb_add/del

[Vladimir Oltean <olteanv@gmail.com>]

On Wed, Nov 17, 2021 at 10:04:46PM +0100, Ansuel Smith wrote:
> Add support for mdb add/del function. The ARL table is used to insert
> the rule. A new search function is introduced to search the rule and add
> additional port to it. If every port is removed from the rule, it's
> removed. It's set STATIC in the ARL table (aka it doesn't age) to not be
> flushed by fast age function.
> 
> Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
> ---
>  drivers/net/dsa/qca8k.c | 82 +++++++++++++++++++++++++++++++++++++++++
>  1 file changed, 82 insertions(+)
> 
> diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
> index dda99263fe8c..a217c842ab45 100644
> --- a/drivers/net/dsa/qca8k.c
> +++ b/drivers/net/dsa/qca8k.c
> @@ -417,6 +417,23 @@ qca8k_fdb_flush(struct qca8k_priv *priv)
>  	mutex_unlock(&priv->reg_mutex);
>  }
>  
> +static int
> +qca8k_fdb_search(struct qca8k_priv *priv, struct qca8k_fdb *fdb, const u8 *mac, u16 vid)
> +{
> +	int ret;
> +
> +	mutex_lock(&priv->reg_mutex);

If I were you, I'd create a locking scheme where the entire FDB entry is
updated under the same critical section. Right now you're relying on the
rtnl_mutex serializing calls to ->port_mdb_add()/->port_mdb_del(). But
that might change. Don't leave that task to someone that has non-expert
knowledge of the driver.

> +	qca8k_fdb_write(priv, vid, 0, mac, 0);
> +	ret = qca8k_fdb_access(priv, QCA8K_FDB_SEARCH, -1);
> +	if (ret < 0)
> +		goto exit;
> +
> +	ret = qca8k_fdb_read(priv, fdb);
> +exit:
> +	mutex_unlock(&priv->reg_mutex);
> +	return ret;
> +}
> +
>  static int
>  qca8k_vlan_access(struct qca8k_priv *priv, enum qca8k_vlan_cmd cmd, u16 vid)
>  {
> @@ -1959,6 +1976,69 @@ qca8k_port_fdb_dump(struct dsa_switch *ds, int port,
>  	return 0;
>  }
>  
> +static int
> +qca8k_port_mdb_add(struct dsa_switch *ds, int port,
> +		   const struct switchdev_obj_port_mdb *mdb)
> +{
> +	struct qca8k_priv *priv = ds->priv;
> +	struct qca8k_fdb fdb = { 0 };
> +	const u8 *addr = mdb->addr;
> +	u8 port_mask = BIT(port);

This doesn't really need to be kept in a temporary variable as it is
only used once.

> +	u16 vid = mdb->vid;
> +	int ret;
> +
> +	/* Check if entry already exist */
> +	ret = qca8k_fdb_search(priv, &fdb, addr, vid);
> +	if (ret < 0)
> +		return ret;
> +
> +	/* Rule exist. Delete first */
> +	if (!fdb.aging) {
> +		ret = qca8k_fdb_del(priv, addr, fdb.port_mask, vid);
> +		if (ret)
> +			return ret;
> +	}
> +
> +	/* Add port to fdb portmask */
> +	fdb.port_mask |= port_mask;
> +
> +	return qca8k_port_fdb_insert(priv, addr, fdb.port_mask, vid);
> +}
> +
> +static int
> +qca8k_port_mdb_del(struct dsa_switch *ds, int port,
> +		   const struct switchdev_obj_port_mdb *mdb)
> +{
> +	struct qca8k_priv *priv = ds->priv;
> +	struct qca8k_fdb fdb = { 0 };
> +	const u8 *addr = mdb->addr;
> +	u8 port_mask = BIT(port);
> +	u16 vid = mdb->vid;
> +	int ret;
> +
> +	/* Check if entry already exist */
> +	ret = qca8k_fdb_search(priv, &fdb, addr, vid);
> +	if (ret < 0)
> +		return ret;
> +
> +	/* Rule doesn't exist. Why delete? */

Because refcounting is hard. In fact with VLANs it is quite possible to
delete an absent entry. For MDBs and FDBs, the bridge should now error
out before it even reaches to you.

> +	if (!fdb.aging)
> +		return -EINVAL;
> +
> +	ret = qca8k_fdb_del(priv, addr, port_mask, vid);
> +	if (ret)
> +		return ret;
> +
> +	/* Only port in the rule is this port. Don't re insert */
> +	if (fdb.port_mask == port_mask)
> +		return 0;
> +
> +	/* Remove port from port mask */
> +	fdb.port_mask &= ~port_mask;
> +
> +	return qca8k_port_fdb_insert(priv, addr, fdb.port_mask, vid);
> +}
> +
>  static int
>  qca8k_port_mirror_add(struct dsa_switch *ds, int port,
>  		      struct dsa_mall_mirror_tc_entry *mirror,
> @@ -2160,6 +2240,8 @@ static const struct dsa_switch_ops qca8k_switch_ops = {
>  	.port_fdb_add		= qca8k_port_fdb_add,
>  	.port_fdb_del		= qca8k_port_fdb_del,
>  	.port_fdb_dump		= qca8k_port_fdb_dump,
> +	.port_mdb_add		= qca8k_port_mdb_add,
> +	.port_mdb_del		= qca8k_port_mdb_del,
>  	.port_mirror_add	= qca8k_port_mirror_add,
>  	.port_mirror_del	= qca8k_port_mirror_del,
>  	.port_vlan_filtering	= qca8k_port_vlan_filtering,
> -- 
> 2.32.0
>