[PATCH 5.19 04/38] pinctrl: rockchip: Enhance support for IRQ_TYPE_EDGE_BOTH

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

From: João H. Spies <jhlspies@gmail.com>

[ Upstream commit b871656aa4f54e04207f62bdd0d7572be1d86b36 ]

Switching between falling/rising edges for IRQ_TYPE_EDGE_BOTH on pins that
require debounce can cause the device to lose events due to a desync
between pin state and irq type.

This problem is resolved by switching between IRQ_TYPE_LEVEL_LOW and
IRQ_TYPE_LEVEL_HIGH instead.

Fixes: 936ee2675eee ("gpio/rockchip: add driver for rockchip gpio")
Signed-off-by: João H. Spies <jhlspies@gmail.com>
Link: https://lore.kernel.org/r/20220808025121.110223-1-jhlspies@gmail.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/gpio/gpio-rockchip.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-rockchip.c b/drivers/gpio/gpio-rockchip.c
index e342a6dc4c6c..bb953f647864 100644
--- a/drivers/gpio/gpio-rockchip.c
+++ b/drivers/gpio/gpio-rockchip.c
@@ -418,11 +418,11 @@ static int rockchip_irq_set_type(struct irq_data *d, unsigned int type)
 			goto out;
 		} else {
 			bank->toggle_edge_mode |= mask;
-			level |= mask;
+			level &= ~mask;
 
 			/*
 			 * Determine gpio state. If 1 next interrupt should be
-			 * falling otherwise rising.
+			 * low otherwise high.
 			 */
 			data = readl(bank->reg_base + bank->gpio_regs->ext_port);
 			if (data & mask)
-- 
2.35.1