[PATCH 5/5] drm/panel: st7703: Drive XBD599 panel at higher clock rate

[Frank Oltmanns <frank@oltmanns.dev>]

This panel is used in the pinephone that runs on a Allwinner A64 SOC.
Acoording to it's datasheet, the SOC requires PLL-MIPI to run at more
than 500 MHz.

Therefore, change [hv]sync_(start|end) so that we reach a clock rate
that is high enough to drive PLL-MIPI within its limits.

Signed-off-by: Frank Oltmanns <frank@oltmanns.dev>
---
 drivers/gpu/drm/panel/panel-sitronix-st7703.c | 14 +++++++-------
 1 file changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/gpu/drm/panel/panel-sitronix-st7703.c b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
index b55bafd1a8be..6886fd7f765e 100644
--- a/drivers/gpu/drm/panel/panel-sitronix-st7703.c
+++ b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
@@ -320,14 +320,14 @@ static int xbd599_init_sequence(struct st7703 *ctx)
 
 static const struct drm_display_mode xbd599_mode = {
 	.hdisplay    = 720,
-	.hsync_start = 720 + 40,
-	.hsync_end   = 720 + 40 + 40,
-	.htotal	     = 720 + 40 + 40 + 40,
+	.hsync_start = 720 + 65,
+	.hsync_end   = 720 + 65 + 65,
+	.htotal      = 720 + 65 + 65 + 65,
 	.vdisplay    = 1440,
-	.vsync_start = 1440 + 18,
-	.vsync_end   = 1440 + 18 + 10,
-	.vtotal	     = 1440 + 18 + 10 + 17,
-	.clock	     = 69000,
+	.vsync_start = 1440 + 30,
+	.vsync_end   = 1440 + 30 + 22,
+	.vtotal	     = 1440 + 30 + 22 + 29,
+	.clock	     = (720 + 65 + 65 + 65) * (1440 + 30 + 22 + 29) * 60 / 1000,
 	.flags	     = DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC,
 	.width_mm    = 68,
 	.height_mm   = 136,

-- 
2.43.0