From: Bhargav Raviprakash <bhargav.r@ltts.com>
To: linux-kernel@vger.kernel.org
Cc: m.nirmaladevi@ltts.com, lee@kernel.org, robh+dt@kernel.org,
krzysztof.kozlowski+dt@linaro.org, conor+dt@kernel.org,
jpanis@baylibre.com, devicetree@vger.kernel.org, arnd@arndb.de,
gregkh@linuxfoundation.org, lgirdwood@gmail.com,
broonie@kernel.org, linus.walleij@linaro.org,
linux-gpio@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
nm@ti.com, vigneshr@ti.com, kristo@kernel.org,
eblanc@baylibre.com, Bhargav Raviprakash <bhargav.r@ltts.com>
Subject: [PATCH v3 00/11] Add support for TI TPS65224 PMIC
Date: Fri, 8 Mar 2024 16:04:44 +0530 [thread overview]
Message-ID: <20240308103455.242705-1-bhargav.r@ltts.com> (raw)
This series modifies the existing TPS6594 drivers to add support for the
TPS65224 PMIC device that is a derivative of TPS6594. TPS65224 has a
similar register map to TPS6594 with a few differences. SPI, I2C, ESM,
PFSM, Regulators and GPIO features overlap between the two devices.
TPS65224 is a Power Management IC (PMIC) which provides regulators and
other features like GPIOs, Watchdog, Error Signal Monitor (ESM) and
Pre-configurable Finite State Machine (PFSM). The SoC and the PMIC can
communicate through the I2C or SPI interfaces. The PMIC TPS65224
additionally has a 12-bit ADC.
Data Sheet for TPS65224: https://www.ti.com/product/TPS65224-Q1
Driver re-use is applied following the advice of the following series:
https://lore.kernel.org/lkml/2f467b0a-1d11-4ec7-8ca6-6c4ba66e5887@baylibre.com/
The features implemented in this series are:
- TPS65224 Register definitions
- Core (MFD I2C and SPI entry points)
- PFSM
- Regulators
- Pinctrl
TPS65224 Register definitions:
This patch adds macros for register field definitions of TPS65224
to the existing TPS6594 driver.
Core description:
I2C and SPI interface protocols are implemented, with and without
the bit-integrity error detection feature (CRC mode).
PFSM description:
Strictly speaking, PFSM is not hardware. It is a piece of code.
PMIC integrates a state machine which manages operational modes.
Depending on the current operational mode, some voltage domains
remain energized while others can be off.
PFSM driver can be used to trigger transitions between configured
states.
Regulators description:
4 BUCKs and 3 LDOs.
BUCK12 can be used in dual-phase mode.
Pinctrl description:
TPS65224 family has 6 GPIOs. Those GPIOs can also serve different
functions such as I2C or SPI interface or watchdog disable functions.
The driver provides both pinmuxing for the functions and GPIO capability.
This series was tested on linux-next tag: next-20240118
Test logs can be found here:
https://gist.github.com/LeonardMH/58ec135921fb1062ffd4a8b384831eb0
Changelog v2 -> v3:
- Corrected comments and refactored ioctl fn in pfsm driver
- Commit message and description changes in SPI
- Removed unwanted comments, fixing indentation and minor refactoring
in regulator driver
- ESM driver is removed from linux as it will be handled from MCU side
Bhargav Raviprakash (8):
mfd: tps6594: use volatile_table instead of volatile_reg
mfd: tps6594: add regmap config in match data
dt-bindings: mfd: ti,tps6594: Add TI TPS65224 PMIC
mfd: tps6594-i2c: Add TI TPS65224 PMIC I2C
mfd: tps6594-spi: Add TI TPS65224 PMIC SPI
mfd: tps6594-core: Add TI TPS65224 PMIC core
misc: tps6594-pfsm: Add TI TPS65224 PMIC PFSM
arch: arm64: dts: ti: k3-am62p5-sk: Add TPS65224 PMIC support in AM62P
dts
Nirmala Devi Mal Nadar (3):
mfd: tps6594: Add register definitions for TI TPS65224 PMIC
regulator: tps6594-regulator: Add TI TPS65224 PMIC regulators
pinctrl: pinctrl-tps6594: Add TPS65224 PMIC pinctrl and GPIO
.../devicetree/bindings/mfd/ti,tps6594.yaml | 1 +
arch/arm64/boot/dts/ti/k3-am62p5-sk.dts | 95 +++++
drivers/mfd/tps6594-core.c | 253 ++++++++++--
drivers/mfd/tps6594-i2c.c | 41 +-
drivers/mfd/tps6594-spi.c | 43 +-
drivers/misc/tps6594-pfsm.c | 48 ++-
drivers/pinctrl/pinctrl-tps6594.c | 287 ++++++++++++--
drivers/regulator/Kconfig | 4 +-
drivers/regulator/tps6594-regulator.c | 236 +++++++++--
include/linux/mfd/tps6594.h | 369 +++++++++++++++++-
10 files changed, 1239 insertions(+), 138 deletions(-)
base-commit: 2863b714f3ad0a9686f2de1b779228ad8c7a8052
--
2.25.1
next reply other threads:[~2024-03-08 10:35 UTC|newest]
Thread overview: 23+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-03-08 10:34 Bhargav Raviprakash [this message]
2024-03-08 10:34 ` [PATCH v3 01/11] mfd: tps6594: Add register definitions for TI TPS65224 PMIC Bhargav Raviprakash
2024-03-08 11:24 ` Julien Panis
2024-03-20 10:13 ` Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 02/11] mfd: tps6594: use volatile_table instead of volatile_reg Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 03/11] mfd: tps6594: add regmap config in match data Bhargav Raviprakash
2024-03-14 13:30 ` Dan Carpenter
2024-03-20 10:22 ` Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 04/11] dt-bindings: mfd: ti,tps6594: Add TI TPS65224 PMIC Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 05/11] mfd: tps6594-i2c: Add TI TPS65224 PMIC I2C Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 06/11] mfd: tps6594-spi: Add TI TPS65224 PMIC SPI Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 07/11] mfd: tps6594-core: Add TI TPS65224 PMIC core Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 08/11] misc: tps6594-pfsm: Add TI TPS65224 PMIC PFSM Bhargav Raviprakash
2024-03-08 10:58 ` Julien Panis
2024-03-08 10:34 ` [PATCH v3 09/11] regulator: tps6594-regulator: Add TI TPS65224 PMIC regulators Bhargav Raviprakash
2024-03-14 11:28 ` Esteban Blanc
2024-03-20 10:15 ` Bhargav Raviprakash
2024-03-14 13:30 ` Dan Carpenter
2024-03-20 10:17 ` Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 10/11] pinctrl: pinctrl-tps6594: Add TPS65224 PMIC pinctrl and GPIO Bhargav Raviprakash
2024-03-14 11:29 ` Esteban Blanc
2024-03-20 10:18 ` Bhargav Raviprakash
2024-03-08 10:34 ` [PATCH v3 11/11] arch: arm64: dts: ti: k3-am62p5-sk: Add TPS65224 PMIC support in AM62P dts Bhargav Raviprakash
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240308103455.242705-1-bhargav.r@ltts.com \
--to=bhargav.r@ltts.com \
--cc=arnd@arndb.de \
--cc=broonie@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=eblanc@baylibre.com \
--cc=gregkh@linuxfoundation.org \
--cc=jpanis@baylibre.com \
--cc=kristo@kernel.org \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=lee@kernel.org \
--cc=lgirdwood@gmail.com \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=m.nirmaladevi@ltts.com \
--cc=nm@ti.com \
--cc=robh+dt@kernel.org \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).