Re: [PATCH 5.10 00/40] 5.10.3-rc1 review

From: Jeffrin Jose T <jeffrin@rajagiritech.edu.in>
To: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Cc: Guenter Roeck <linux@roeck-us.net>, Pavel Machek <pavel@denx.de>,
	linux-kernel@vger.kernel.org, torvalds@linux-foundation.org,
	akpm@linux-foundation.org, shuah@kernel.org,
	patches@kernelci.org, lkft-triage@lists.linaro.org,
	stable@vger.kernel.org
Subject: Re: [PATCH 5.10 00/40] 5.10.3-rc1 review
Date: Thu, 07 Jan 2021 01:08:01 +0530	[thread overview]
Message-ID: <4474633bf649e93f3292d8d248b352066c063a20.camel@rajagiritech.edu.in> (raw)
In-Reply-To: <X/Kz4KHxoU/YYEvu@kroah.com>

On Mon, 2021-01-04 at 07:21 +0100, Greg Kroah-Hartman wrote:
> On Sun, Jan 03, 2021 at 06:37:51PM +0530, Jeffrin Jose T wrote:
> > On Mon, 2020-12-28 at 12:41 -0800, Guenter Roeck wrote:
> > > On 12/28/20 1:50 AM, Pavel Machek wrote:
> > > > Hi!
> > > > 
> > > > > > > > > > https://www.kernel.org/pub/linux/kernel/v5.x/stable-review/patch-5.10.3-rc1.gz
> > > > > > > > > > or in the git tree and branch at:
> > > > > > > > > >         git://git.kernel.org/pub/scm/linux/kernel/g
> > > > > > > > > > it/s
> > > > > > > > > > table/
> > > > > > > > > > linu
> > > > > > > > > > x-
> > > > > > > > > > stable-rc.git linux-5.10.y
> > > > > > > > > > and the diffstat can be found below.
> > > > > > > > > > 
> > > > > > > > > > thanks,
> > > > > > > > > > 
> > > > > > > > > > greg k-h
> > > > > > > > > 
> > > > > > > > > hello ,
> > > > > > > > > Compiled and booted 5.10.3-rc1+.
> > > > > > > > > 
> > > > > > > > > dmesg -l err gives...
> > > > > > > > > --------------x-------------x------------------->
> > > > > > > > >    43.190922] Bluetooth: hci0: don't support firmware
> > > > > > > > > rome
> > > > > > > > > 0x31010100
> > > > > > > > > --------------x---------------x----------------->
> > > > > > > > > 
> > > > > > > > > My Bluetooth is Off.
> > > > > > > > 
> > > > > > > > Is this a new warning?  Does it show up on 5.10.2?
> > > > > > > > 
> > > > > > > > > Tested-by: Jeffrin Jose T <
> > > > > > > > > jeffrin@rajagiritech.edu.in>
> > > > > > > > 
> > > > > > > > thanks for testing?
> > > > > > > > 
> > > > > > > > greg k-h
> > > > > > > 
> > > > > > > this does not show up in 5.10.2-rc1+
> > > > > > 
> > > > > > Odd.  Can you run 'git bisect' to find the offending
> > > > > > commit?
> > > > > > 
> > > > > > Does this same error message show up in Linus's git tree?
> > > > 
> > > > > i will try to do "git bisect" .  i saw this error in linus's 
> > > > > tree.
> > > > 
> > > > The bug is in -stable, too, so it is probably easiest to do
> > > > bisect
> > > > on
> > > > -stable tree. IIRC there's less then few hundred commits, so it
> > > > should
> > > > be feasible to do bisection by hand if you are not familiar
> > > > with
> > > > git
> > > > bisect.
> > > > 
> > > 
> > > My wild guess would be commit b260e4a68853 ("Bluetooth: Fix slab-
> > > out-
> > > of-bounds
> > > read in hci_le_direct_adv_report_evt()"), but I don't see what
> > > might
> > > be wrong
> > > with it unless some BT device sends a bad report which used to be
> > > accepted
> > > but is now silently ignored.
> > > 
> > > Guenter
> > > 
> > hello,
> > 
> > Did  "git bisect" in  a typically ok fashion and found that 5.9.0
> > is
> > working for bluetooth related. But 5.10.0-rc1  related is not
> > working.
> > 
> > some related information in bisect.txt  attached.
> > 
> > -- 
> > software engineer
> > rajagiri school of engineering and technology - autonomous
> > 
> 
> > $sudo git bisect bad
> > Bisecting: 0 revisions left to test after this (roughly 1 step)
> > [194810f78402128fe07676646cf9027fd3ed431c] dt-bindings: leds:
> > Update devicetree documents for ID_RGB
> > 
> > $sudo git bisect bad
> > Bisecting: 0 revisions left to test after this (roughly 0 steps)
> > [3650b228f83adda7e5ee532e2b90429c03f7b9ec] Linux 5.10-rc1
> 
> That's really odd, as that commit only has a Makefile change.

i will try to work on it again

> Also, why run this as root?
> 
there may be some problem in my sudo configurtion or the way in run
sudo.\
when i run "make modules_install" and "make install" using sudo typical
files 
ownership changes to root.

-- 
software engineer
rajagiri school of engineering and technology - autonomous