LKML Archive on lore.kernel.org
 help / color / Atom feed
* [PATCH v2] remoteproc: qcom_q6v5: Assign mpss region to Q6 before MBA boot
@ 2020-09-16 14:52 Sibi Sankar
  2020-09-16 17:17 ` Stephen Boyd
  0 siblings, 1 reply; 3+ messages in thread
From: Sibi Sankar @ 2020-09-16 14:52 UTC (permalink / raw)
  To: bjorn.andersson
  Cc: agross, linux-arm-msm, linux-remoteproc, linux-kernel, ohad,
	evgreen, swboyd, Sibi Sankar

On secure devices which support warm reset, the MBA firmware requires
access to the modem region to clear them out. Hence provide Q6 access
to this region before MBA boot. This will be a nop during a modem SSR.

Signed-off-by: Sibi Sankar <sibis@codeaurora.org>
---

V2:
 * Fixup comments as suggested by Bjorn. 

 drivers/remoteproc/qcom_q6v5_mss.c | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/remoteproc/qcom_q6v5_mss.c b/drivers/remoteproc/qcom_q6v5_mss.c
index c401bcc263fa..f989ca81d374 100644
--- a/drivers/remoteproc/qcom_q6v5_mss.c
+++ b/drivers/remoteproc/qcom_q6v5_mss.c
@@ -931,6 +931,16 @@ static int q6v5_mba_load(struct q6v5 *qproc)
 		goto assert_reset;
 	}
 
+	/* Some versions of the MBA firmware will upon boot wipe the MPSS region as well, so provide
+	 * the Q6 access to this region.
+	 */
+	ret = q6v5_xfer_mem_ownership(qproc, &qproc->mpss_perm, false, true,
+				      qproc->mpss_phys, qproc->mpss_size);
+	if (ret) {
+		dev_err(qproc->dev, "assigning Q6 access to mpss memory failed: %d\n", ret);
+		goto disable_active_clks;
+	}
+
 	/* Assign MBA image access in DDR to q6 */
 	ret = q6v5_xfer_mem_ownership(qproc, &qproc->mba_perm, false, true,
 				      qproc->mba_phys, qproc->mba_size);
@@ -1137,8 +1147,7 @@ static int q6v5_mpss_load(struct q6v5 *qproc)
 
 	/**
 	 * In case of a modem subsystem restart on secure devices, the modem
-	 * memory can be reclaimed only after MBA is loaded. For modem cold
-	 * boot this will be a nop
+	 * memory can be reclaimed only after MBA is loaded.
 	 */
 	q6v5_xfer_mem_ownership(qproc, &qproc->mpss_perm, true, false,
 				qproc->mpss_phys, qproc->mpss_size);
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project


^ permalink raw reply	[flat|nested] 3+ messages in thread

end of thread, back to index

Thread overview: 3+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2020-09-16 14:52 [PATCH v2] remoteproc: qcom_q6v5: Assign mpss region to Q6 before MBA boot Sibi Sankar
2020-09-16 17:17 ` Stephen Boyd
2020-09-17 15:59   ` Sibi Sankar

LKML Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/lkml/0 lkml/git/0.git
	git clone --mirror https://lore.kernel.org/lkml/1 lkml/git/1.git
	git clone --mirror https://lore.kernel.org/lkml/2 lkml/git/2.git
	git clone --mirror https://lore.kernel.org/lkml/3 lkml/git/3.git
	git clone --mirror https://lore.kernel.org/lkml/4 lkml/git/4.git
	git clone --mirror https://lore.kernel.org/lkml/5 lkml/git/5.git
	git clone --mirror https://lore.kernel.org/lkml/6 lkml/git/6.git
	git clone --mirror https://lore.kernel.org/lkml/7 lkml/git/7.git
	git clone --mirror https://lore.kernel.org/lkml/8 lkml/git/8.git
	git clone --mirror https://lore.kernel.org/lkml/9 lkml/git/9.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 lkml lkml/ https://lore.kernel.org/lkml \
		linux-kernel@vger.kernel.org
	public-inbox-index lkml

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-kernel


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git