From: Cristian Ciocaltea <cristian.ciocaltea@collabora.com>
To: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>,
"David S. Miller" <davem@davemloft.net>,
Eric Dumazet <edumazet@google.com>,
Jakub Kicinski <kuba@kernel.org>, Paolo Abeni <pabeni@redhat.com>,
Rob Herring <robh+dt@kernel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
Conor Dooley <conor+dt@kernel.org>,
Emil Renner Berthing <kernel@esmil.dk>,
Samin Guo <samin.guo@starfivetech.com>,
Paul Walmsley <paul.walmsley@sifive.com>,
Palmer Dabbelt <palmer@dabbelt.com>,
Albert Ou <aou@eecs.berkeley.edu>,
Hal Feng <hal.feng@starfivetech.com>,
Michael Turquette <mturquette@baylibre.com>,
Stephen Boyd <sboyd@kernel.org>,
Alexandre Torgue <alexandre.torgue@foss.st.com>,
Jose Abreu <joabreu@synopsys.com>,
Maxime Coquelin <mcoquelin.stm32@gmail.com>,
Richard Cochran <richardcochran@gmail.com>,
Giuseppe Cavallaro <peppe.cavallaro@st.com>
Cc: netdev@vger.kernel.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org, linux-riscv@lists.infradead.org,
linux-clk@vger.kernel.org,
linux-stm32@st-md-mailman.stormreply.com,
linux-arm-kernel@lists.infradead.org, kernel@collabora.com
Subject: Re: [PATCH v4 2/9] dt-bindings: net: starfive,jh7110-dwmac: Add JH7100 SoC compatible
Date: Tue, 19 Dec 2023 15:36:58 +0200 [thread overview]
Message-ID: <50f0a002-f602-4cdb-ab18-e085adbf09bc@collabora.com> (raw)
In-Reply-To: <15077e1f-c13b-4424-9918-df441b56b695@linaro.org>
On 12/19/23 15:19, Krzysztof Kozlowski wrote:
> On 19/12/2023 13:49, Cristian Ciocaltea wrote:
>>>> reg:
>>>> maxItems: 1
>>>> @@ -46,23 +50,6 @@ properties:
>>>> - const: tx
>>>> - const: gtx
>>>>
>>>> - interrupts:
>>>> - minItems: 3
>>>> - maxItems: 3
>>>> -
>>>> - interrupt-names:
>>>> - minItems: 3
>>>> - maxItems: 3
>>>> -
>>>> - resets:
>>>> - minItems: 2
>>>> - maxItems: 2
>>>
>>> What is the point of your previous patch if you immediately remove it?
>>> It is a no-op. Just mention in this commit msg, that both resets and
>>> reset-names are coming from snps,dwmac so they can be removed from
>>> top-level entirely.
>>
>> This has been discussed during v2 review [1], where I also provided the
>> rational behind not updating reset-names. So the code was not deleted,
>> but moved under an if clause.
>>
>> Thanks for reviewing,
>> Cristian
>>
>> [1]: https://lore.kernel.org/lkml/f4d0b216-5bdc-4559-aabb-8af638d33721@collabora.com/
>
> I don't see it being addressed:
>
> https://lore.kernel.org/lkml/35556392-3b9a-4997-b482-082dc2f9121f@linaro.org/
>
> Repeating the same and the same :/
I think this was just a misunderstanding, sorry for the confusion. I
kept two sets of changes which were not directly related into separate
patches, so I'm going to squash them in v5.
Thanks,
Cristian
next prev parent reply other threads:[~2023-12-19 13:37 UTC|newest]
Thread overview: 23+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-12-18 21:44 [PATCH v4 0/9] Enable networking support for StarFive JH7100 SoC Cristian Ciocaltea
2023-12-18 21:44 ` [PATCH v4 1/9] dt-bindings: net: starfive,jh7110-dwmac: Drop redundant reset description Cristian Ciocaltea
2023-12-19 7:24 ` Krzysztof Kozlowski
2023-12-19 12:55 ` Cristian Ciocaltea
2023-12-19 13:22 ` Krzysztof Kozlowski
2023-12-18 21:44 ` [PATCH v4 2/9] dt-bindings: net: starfive,jh7110-dwmac: Add JH7100 SoC compatible Cristian Ciocaltea
2023-12-19 7:27 ` Krzysztof Kozlowski
2023-12-19 12:49 ` Cristian Ciocaltea
2023-12-19 13:19 ` Krzysztof Kozlowski
2023-12-19 13:36 ` Cristian Ciocaltea [this message]
2023-12-18 21:44 ` [PATCH v4 3/9] net: stmmac: dwmac-starfive: Add support for JH7100 SoC Cristian Ciocaltea
2023-12-19 9:04 ` Andrew Lunn
2023-12-18 21:44 ` [PATCH v4 4/9] riscv: dts: starfive: jh7100: Add sysmain and gmac DT nodes Cristian Ciocaltea
2023-12-18 21:44 ` [PATCH v4 5/9] riscv: dts: starfive: jh7100-common: Setup pinmux and enable gmac Cristian Ciocaltea
2023-12-18 21:44 ` [PATCH v4 6/9] riscv: dts: starfive: visionfive-v1: Setup ethernet phy Cristian Ciocaltea
2023-12-19 8:58 ` Andrew Lunn
2023-12-18 21:44 ` [PATCH v4 7/9] riscv: dts: starfive: beaglev-starlight: Setup phy reset gpio Cristian Ciocaltea
2023-12-18 21:44 ` [PATCH v4 8/9] clk: starfive: Add flags argument to JH71X0__MUX macro Cristian Ciocaltea
2023-12-18 21:44 ` [PATCH v4 9/9] clk: starfive: jh7100: Add CLK_SET_RATE_PARENT to gmac_tx Cristian Ciocaltea
2023-12-18 22:53 ` [PATCH v4 0/9] Enable networking support for StarFive JH7100 SoC Jacob Keller
2023-12-18 22:59 ` Cristian Ciocaltea
2023-12-19 9:03 ` Andrew Lunn
2023-12-19 13:20 ` Cristian Ciocaltea
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=50f0a002-f602-4cdb-ab18-e085adbf09bc@collabora.com \
--to=cristian.ciocaltea@collabora.com \
--cc=alexandre.torgue@foss.st.com \
--cc=aou@eecs.berkeley.edu \
--cc=conor+dt@kernel.org \
--cc=davem@davemloft.net \
--cc=devicetree@vger.kernel.org \
--cc=edumazet@google.com \
--cc=hal.feng@starfivetech.com \
--cc=joabreu@synopsys.com \
--cc=kernel@collabora.com \
--cc=kernel@esmil.dk \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=krzysztof.kozlowski@linaro.org \
--cc=kuba@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-riscv@lists.infradead.org \
--cc=linux-stm32@st-md-mailman.stormreply.com \
--cc=mcoquelin.stm32@gmail.com \
--cc=mturquette@baylibre.com \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=palmer@dabbelt.com \
--cc=paul.walmsley@sifive.com \
--cc=peppe.cavallaro@st.com \
--cc=richardcochran@gmail.com \
--cc=robh+dt@kernel.org \
--cc=samin.guo@starfivetech.com \
--cc=sboyd@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).