Re: [PATCH v11 00/27] ARM: davinci: convert to common clock framework​

[Sekhar Nori <nsekhar@ti.com>]

Hi David,

On Sunday 17 June 2018 09:18 PM, David Lechner wrote:
> Hi Sekhar,
> 
> On 05/22/2018 04:38 AM, Sekhar Nori wrote:
>> Hi David,
>>
>> On Friday 18 May 2018 10:18 PM, David Lechner wrote:
>>> This series converts mach-davinci to use the common clock framework.
>>>
>>> The series works like this, the first 3 patches fix some issues with
>>> the clock
>>> drivers that have already been accepted into the mainline kernel.
>>>
>>> Then, starting with "ARM: davinci: pass clock as parameter to
>>> davinci_timer_init()", we get the mach code ready for the switch by
>>> adding the
>>> code needed for the new clock drivers and adding #ifndef
>>> CONFIG_COMMON_CLK
>>> around the legacy clocks so that we can switch easily between the old
>>> and the
>>> new.
>>>
>>> "ARM: davinci: switch to common clock framework" actually flips the
>>> switch
>>> to start using the new clock drivers. Then the next 8 patches remove all
>>> of the old clock code.
>>>
>>> The final four patches add device tree clock support to the one SoC that
>>> supports it.
>>>
>>> This series has been tested on TI OMAP-L138 LCDK (both device tree
>>> and legacy
>>> board file).
>>
>> If you do end up sending a v12, you can leave out the mach-davinci
>> portions unless there are any changes you need to make. I will pick them
>> up from this series once the driver dependencies are merged.
>>
>> I do hope the drivers/clk/* changes can be merged from v4.18.
>>
>> Thanks,
>> Sekhar
>>
> 
> Are you going to pick up the arch patches from this series now that
> the 4.18 merge window is closed?
> 
> All of the clk patches landed in 4.18.

yes!

Thanks,
Sekhar