Re: [RFE net-next] net: tun: 1000x speed up

[Nicolas Dichtel <nicolas.dichtel@6wind.com>]

Le 24/10/2022 à 13:56, Ilya Maximets a écrit :
> On 10/24/22 11:44, Nicolas Dichtel wrote:
>> Le 21/10/2022 à 18:07, Jakub Kicinski a écrit :
>>> On Fri, 21 Oct 2022 13:49:21 +0200 Ilya Maximets wrote:
>>>> Bump the advertised speed to at least match the veth.  10Gbps also
>>>> seems like a more or less fair assumption these days, even though
>>>> CPUs can do more.  Alternative might be to explicitly report UNKNOWN
>>>> and let the application/user decide on a right value for them.
>>>
>>> UNKOWN would seem more appropriate but at this point someone may depend
>>> on the speed being populated so it could cause regressions, I fear :S
>> If it is put in a bonding, it may cause some trouble. Maybe worth than
>> advertising 10M.
> 
> My thoughts were that changing the number should have a minimal impact
> while changing it to not report any number may cause some issues in
> applications that doesn't expect that for some reason (not having a
> fallback in case reported speed is unknown isn't great, and the argument
> can be made that applications should check that, but it's hard to tell
> for every application if they actually do that today).
> 
> Bonding is also a good point indeed, since it's even in-kernel user.
> 
> 
> The speed bump doesn't solve the problem per se.  It kind of postpones
> the decision, since we will run into the same issue eventually again.
> That's why I wanted to discuss that first.
> 
> Though I think that at least unification across virtual devices (tun and
> veth) should be a step in a right direction.
Just to make it clear, I'm not against aligning speed with veth, I'm only
against reporting UNKNOWN.

> 
>>
>> Note that this value could be configured with ethtool:
>> https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/?id=4e24f2dd516ed
> 
> This is interesting, but it's a bit hard to manage, because in order
> to make a decision to bump the speed, application should already know
> that this is a tun/tap device.  So, there has to be a special case
But this should be done by the application which creates this tun interface. Not
by the application that uses this information.

> implemented in the code that detects the driver and changes the speed
> (this is about application that is using the interface, but didn't
> create it), but if we already know the driver, then it doesn't make
> sense to actually change the speed in many cases as application can
> already act accordingly.
> 
> Also, the application may not have permissions to do that (I didn't
> check the requirements, but my guess would be at least CAP_NET_ADMIN?).
Sure, but the one who creates it, has the right to configure it correctly. It's
part of the configuration of the interface.

Setting an higher default speed seems to be a workaround to fix an incorrect
configuration. And as you said, it will probably be wrong again in a few years ;-)

> 
> For the human user it's still one extra configuration step that they
> need to remember to perform.
I don't buy this argument. There are already several steps: creating and
configuring an interface requires more than one command.


Regards,
Nicolas