Hi,

Sandeep Maheswaram <sanm@codeaurora.org> writes:
> This patch adds a shutdown callback to USB DWC QCOM driver to ensure that
> it is properly shutdown in reboot/shutdown path. This is required
> where SMMU address translation is enabled like on SC7180
> SoC and few others. If the hardware is still accessing memory after
> SMMU translation is disabled as part of SMMU shutdown callback in
> system reboot or shutdown path, then IOVAs(I/O virtual address)
> which it was using will go on the bus as the physical addresses which
> might result in unknown crashes (NoC/interconnect errors).
>
> Signed-off-by: Sandeep Maheswaram <sanm@codeaurora.org>

sounds like this is fixing a bug. Do you have a Fixes tag for it? Should
this go to stable?

> diff --git a/drivers/usb/dwc3/dwc3-qcom.c b/drivers/usb/dwc3/dwc3-qcom.c
> index c703d55..a930e06 100644
> --- a/drivers/usb/dwc3/dwc3-qcom.c
> +++ b/drivers/usb/dwc3/dwc3-qcom.c
> @@ -790,13 +790,11 @@ static int dwc3_qcom_probe(struct platform_device *pdev)
>  	return ret;
>  }
>  
> -static int dwc3_qcom_remove(struct platform_device *pdev)
> +static void __dwc3_qcom_teardown(struct dwc3_qcom *qcom)
>  {
> -	struct dwc3_qcom *qcom = platform_get_drvdata(pdev);
> -	struct device *dev = &pdev->dev;
>  	int i;
>  
> -	of_platform_depopulate(dev);
> +	of_platform_depopulate(qcom->dev);
>  
>  	for (i = qcom->num_clocks - 1; i >= 0; i--) {
>  		clk_disable_unprepare(qcom->clks[i]);
> @@ -807,12 +805,27 @@ static int dwc3_qcom_remove(struct platform_device *pdev)
>  	dwc3_qcom_interconnect_exit(qcom);
>  	reset_control_assert(qcom->resets);
>  
> -	pm_runtime_allow(dev);
> -	pm_runtime_disable(dev);
> +	pm_runtime_allow(qcom->dev);
> +	pm_runtime_disable(qcom->dev);
> +}

you can make the changes smaller by adding:

	struct device *dev = qcom->dev;

The nothing else needs to change in this function ;-)

-- 
balbi