From: Matthias Brugger <matthias.bgg@gmail.com>
To: Yong Wu <yong.wu@mediatek.com>, Joerg Roedel <joro@8bytes.org>,
Robin Murphy <robin.murphy@arm.com>,
Rob Herring <robh+dt@kernel.org>
Cc: Evan Green <evgreen@chromium.org>, Tomasz Figa <tfiga@google.com>,
Will Deacon <will.deacon@arm.com>,
linux-mediatek@lists.infradead.org, srv_heupstream@mediatek.com,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
iommu@lists.linux-foundation.org, yingjoe.chen@mediatek.com,
youlin.pei@mediatek.com, Nicolas Boichat <drinkcat@chromium.org>,
anan.sun@mediatek.com, Matthias Kaehlcke <mka@chromium.org>
Subject: Re: [PATCH v7 19/21] iommu/mediatek: Rename enable_4GB to dram_is_4gb
Date: Tue, 18 Jun 2019 18:06:47 +0200 [thread overview]
Message-ID: <9bf13c22-0c73-2950-2204-23d577976b03@gmail.com> (raw)
In-Reply-To: <1560169080-27134-20-git-send-email-yong.wu@mediatek.com>
On 10/06/2019 14:17, Yong Wu wrote:
> This patch only rename the variable name from enable_4GB to
> dram_is_4gb for readable.
From my understanding this is true when available RAM > 4GB so I think the name
should be something like dram_bigger_4gb otherwise it may create confusion again.
Also from my point of view this patch should be done before
"[PATCH 06/21] iommu/io-pgtable-arm-v7s: Extend MediaTek 4GB Mode"
Regards,
Matthias
>
> Signed-off-by: Yong Wu <yong.wu@mediatek.com>
> Reviewed-by: Evan Green <evgreen@chromium.org>
> ---
> drivers/iommu/mtk_iommu.c | 10 +++++-----
> drivers/iommu/mtk_iommu.h | 2 +-
> 2 files changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/iommu/mtk_iommu.c b/drivers/iommu/mtk_iommu.c
> index 86158d8..67cab2d 100644
> --- a/drivers/iommu/mtk_iommu.c
> +++ b/drivers/iommu/mtk_iommu.c
> @@ -382,7 +382,7 @@ static int mtk_iommu_map(struct iommu_domain *domain, unsigned long iova,
> int ret;
>
> /* The "4GB mode" M4U physically can not use the lower remap of Dram. */
> - if (data->plat_data->has_4gb_mode && data->enable_4GB)
> + if (data->plat_data->has_4gb_mode && data->dram_is_4gb)
> paddr |= BIT_ULL(32);
>
> spin_lock_irqsave(&dom->pgtlock, flags);
> @@ -554,13 +554,13 @@ static int mtk_iommu_hw_init(const struct mtk_iommu_data *data)
> writel_relaxed(regval, data->base + REG_MMU_INT_MAIN_CONTROL);
>
> if (data->plat_data->m4u_plat == M4U_MT8173)
> - regval = (data->protect_base >> 1) | (data->enable_4GB << 31);
> + regval = (data->protect_base >> 1) | (data->dram_is_4gb << 31);
> else
> regval = lower_32_bits(data->protect_base) |
> upper_32_bits(data->protect_base);
> writel_relaxed(regval, data->base + REG_MMU_IVRP_PADDR);
>
> - if (data->enable_4GB && data->plat_data->has_vld_pa_rng) {
> + if (data->dram_is_4gb && data->plat_data->has_vld_pa_rng) {
> /*
> * If 4GB mode is enabled, the validate PA range is from
> * 0x1_0000_0000 to 0x1_ffff_ffff. here record bit[32:30].
> @@ -611,8 +611,8 @@ static int mtk_iommu_probe(struct platform_device *pdev)
> return -ENOMEM;
> data->protect_base = ALIGN(virt_to_phys(protect), MTK_PROTECT_PA_ALIGN);
>
> - /* Whether the current dram is over 4GB */
> - data->enable_4GB = !!(max_pfn > (BIT_ULL(32) >> PAGE_SHIFT));
> + /* Whether the current dram is 4GB. */
> + data->dram_is_4gb = !!(max_pfn > (BIT_ULL(32) >> PAGE_SHIFT));
>
> res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> data->base = devm_ioremap_resource(dev, res);
> diff --git a/drivers/iommu/mtk_iommu.h b/drivers/iommu/mtk_iommu.h
> index 753266b..e8114b2 100644
> --- a/drivers/iommu/mtk_iommu.h
> +++ b/drivers/iommu/mtk_iommu.h
> @@ -65,7 +65,7 @@ struct mtk_iommu_data {
> struct mtk_iommu_domain *m4u_dom;
> struct iommu_group *m4u_group;
> struct mtk_smi_iommu smi_imu; /* SMI larb iommu info */
> - bool enable_4GB;
> + bool dram_is_4gb;
> bool tlb_flush_active;
>
> struct iommu_device iommu;
>
next prev parent reply other threads:[~2019-06-18 16:06 UTC|newest]
Thread overview: 52+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-06-10 12:17 [PATCH v7 00/21] MT8183 IOMMU SUPPORT Yong Wu
2019-06-10 12:17 ` [PATCH v7 01/21] dt-bindings: mediatek: Add binding for mt8183 IOMMU and SMI Yong Wu
2019-06-10 12:17 ` [PATCH v7 02/21] iommu/mediatek: Use a struct as the platform data Yong Wu
2019-06-10 12:17 ` [PATCH v7 03/21] memory: mtk-smi: Use a general config_port interface Yong Wu
2019-06-10 12:17 ` [PATCH v7 04/21] memory: mtk-smi: Use a struct for the platform data for smi-common Yong Wu
2019-06-10 12:17 ` [PATCH v7 05/21] iommu/io-pgtable-arm-v7s: Add paddr_to_iopte and iopte_to_paddr helpers Yong Wu
2019-06-10 12:17 ` [PATCH v7 06/21] iommu/io-pgtable-arm-v7s: Extend MediaTek 4GB Mode Yong Wu
2019-06-10 12:17 ` [PATCH v7 07/21] iommu/mediatek: Add bclk can be supported optionally Yong Wu
2019-06-15 19:18 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 08/21] iommu/mediatek: Add larb-id remapped support Yong Wu
2019-06-17 9:25 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 09/21] iommu/mediatek: Refine protect memory definition Yong Wu
2019-06-17 9:59 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 10/21] iommu/mediatek: Move reset_axi into plat_data Yong Wu
2019-06-17 10:19 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 11/21] iommu/mediatek: Move vld_pa_rng " Yong Wu
2019-06-17 10:27 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 12/21] memory: mtk-smi: Add gals support Yong Wu
2019-06-17 15:43 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 13/21] iommu/mediatek: Add mt8183 IOMMU support Yong Wu
2019-06-17 15:51 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 14/21] iommu/mediatek: Add mmu1 support Yong Wu
2019-06-17 15:58 ` Matthias Brugger
2019-06-18 6:19 ` Tomasz Figa
2019-06-18 12:09 ` Yong Wu
2019-06-18 14:05 ` Tomasz Figa
2019-06-10 12:17 ` [PATCH v7 15/21] memory: mtk-smi: Invoke pm runtime_callback to enable clocks Yong Wu
2019-06-17 16:13 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 16/21] memory: mtk-smi: Add bus_sel for mt8183 Yong Wu
2019-06-13 8:20 ` Pi-Hsun Shih
2019-06-17 16:28 ` Matthias Brugger
2019-06-17 16:23 ` Matthias Brugger
2019-06-18 12:10 ` Yong Wu
2019-06-18 21:07 ` Matthias Brugger
[not found] ` <CANdKZ0d873PJ2u=Hn_aUJBu3dDiNyueVwBv94-VXHGLJBvAbGg@mail.gmail.com>
2019-06-20 9:35 ` Matthias Brugger
2019-06-20 11:38 ` Matthias Brugger
2019-06-21 3:57 ` Pi-Hsun Shih
2019-06-10 12:17 ` [PATCH v7 17/21] memory: mtk-smi: Get rid of need_larbid Yong Wu
2019-06-18 13:45 ` Matthias Brugger
2019-06-20 13:59 ` Yong Wu
2019-06-10 12:17 ` [PATCH v7 18/21] iommu/mediatek: Fix VLD_PA_RNG register backup when suspend Yong Wu
2019-06-17 16:30 ` Matthias Brugger
2019-06-10 12:17 ` [PATCH v7 19/21] iommu/mediatek: Rename enable_4GB to dram_is_4gb Yong Wu
2019-06-18 16:06 ` Matthias Brugger [this message]
2019-06-20 13:59 ` Yong Wu
2019-06-21 10:10 ` Matthias Brugger
2019-06-22 2:42 ` Yong Wu
2019-06-10 12:17 ` [PATCH v7 20/21] iommu/mediatek: Fix iova_to_phys PA start for 4GB mode Yong Wu
2019-06-18 16:35 ` Matthias Brugger
2019-06-20 14:00 ` Yong Wu
2019-06-10 12:18 ` [PATCH v7 21/21] iommu/mediatek: Switch to SPDX license identifier Yong Wu
2019-06-17 16:33 ` Matthias Brugger
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=9bf13c22-0c73-2950-2204-23d577976b03@gmail.com \
--to=matthias.bgg@gmail.com \
--cc=anan.sun@mediatek.com \
--cc=devicetree@vger.kernel.org \
--cc=drinkcat@chromium.org \
--cc=evgreen@chromium.org \
--cc=iommu@lists.linux-foundation.org \
--cc=joro@8bytes.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mediatek@lists.infradead.org \
--cc=mka@chromium.org \
--cc=robh+dt@kernel.org \
--cc=robin.murphy@arm.com \
--cc=srv_heupstream@mediatek.com \
--cc=tfiga@google.com \
--cc=will.deacon@arm.com \
--cc=yingjoe.chen@mediatek.com \
--cc=yong.wu@mediatek.com \
--cc=youlin.pei@mediatek.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).