Re: [PATCH v2] Input: Add generic driver for Zeitec touchscreens

[Bogdan George Stefan <bogdan.george.stefan@gmail.com>]

Dimitry,

Please let me know if there is anything I can provide for this driver.

Thank you,
Bogdan

On Thu, Jun 18, 2015 at 11:39 AM, Bogdan George Stefan
<bogdan.george.stefan@gmail.com> wrote:
> Dimitry,
>
> You can control how many fingers work on a device via the firmware
> that you load. I've asked the Zeitec guys to confirm. So, to answer
> your question, if you want to build a system with a touch that
> supports only 7 fingers, you can pick any part from Zeitec and give
> the supplier the right firmware.
>
> Thank you,
> Bogdan Stefan
>
> On Fri, Jun 12, 2015 at 3:45 AM, Dmitry Torokhov
> <dmitry.torokhov@gmail.com> wrote:
>>
>> Hi Bogdan,
>>
>> On Tue, Jun 02, 2015 at 10:43:01AM +0300, Bogdan George Stefan wrote:
>> > Dimitry,
>> >
>> > I know 0xB2 should provide that information according to the
>> > datasheet, however here is what Zeitec guys had to say when I asked
>> > them why it does not work:
>> >
>> > "0xB2 is deprecated.
>> > It only supports in Zet6221/31 serious but zet9172/zet6273."
>> >
>> > If you like, I can attach my conversation with them.
>> >
>>
>> Not really, but I would like to understand how the part selection works.
>> Are they the same parts or different parts? Let's say you want to build
>> a system and you want part that reports up to 7 contacts. How do you
>> communicate this to the supplier? The number of contacts - is it
>> controller by the config file you load into the controller, or they have
>> separate parts for different contact count or what?
>>
>> Thanks.
>>
>> --
>> Dmitry