Re: [PATCH v3 3/4] arm: dts: imx: Add i.mx6q DaSheng COM-9XX SBC board support

[dillon min <dillon.minfei@gmail.com>]

Hi Fabio,

Thanks for quick reply.

On Tue, Apr 20, 2021 at 10:27 PM Fabio Estevam <festevam@gmail.com> wrote:
>
> Hi Dillon,
>
> On Thu, Apr 15, 2021 at 1:05 AM <dillon.minfei@gmail.com> wrote:
>
> > +               green {
> > +                       gpios = <&gpio4 8 0>;
>
> Please use GPIO_ACTIVE_HIGH label instead:
> gpios = <&gpio4 8 GPIO_ACTIVE_HIGH>;
>
> > +&clks {
> > +       assigned-clocks = <&clks IMX6QDL_CLK_LDB_DI0_SEL>,
> > +                         <&clks IMX6QDL_CLK_LDB_DI1_SEL>;
> > +       assigned-clock-parents = <&clks IMX6QDL_CLK_PLL3_USB_OTG>,
> > +                                <&clks IMX6QDL_CLK_PLL3_USB_OTG>;
> > +};
>
> You are setting the LDB clock parent, but you don't use LDB in this
> devicetree. You could simply remove this.
Agree, thanks.
>
> > +&ecspi1 {
> > +       cs-gpios = <&gpio4 9 GPIO_ACTIVE_LOW>;
> > +       pinctrl-names = "default";
> > +       pinctrl-0 = <&pinctrl_ecspi1>;
> > +       status = "okay";
> > +
> > +       flash: m25p80@0 {
>
> Node names should be generic:
>
> m25p80: flash@0
Agree, thanks.
>
> > +&iomuxc {
> > +       pinctrl-names = "default";
> > +       pinctrl-0 = <&pinctrl_hog>;
> > +
> > +       imx6qdl-ds {
> > +               pinctrl_hog: hoggrp {
> > +                       fsl,pins = <
> > +                               MX6QDL_PAD_NANDF_D0__GPIO2_IO00 0x1b0b0
> > +                               MX6QDL_PAD_NANDF_D1__GPIO2_IO01 0x1b0b0
> > +                               MX6QDL_PAD_GPIO_0__CCM_CLKO1    0x130b0
>
> This could be part of the pinctrl_ov2659 group as it provides the
> clock for the camera.
>
> Please try to keep in the hoggrp only the pins that cannot be
> controlled by any other node.
Agree, after moving these pinctrl to corresponding component's group,
the hoggrp is useless.
so, I removed it in v4.
>
> > +&wdog1 {
> > +       status = "okay";
> > +};
> > +
> > +&wdog2 {
> > +       pinctrl-names = "default";
> > +       pinctrl-0 = <&pinctrl_wdog>;
> > +       fsl,ext-reset-output;
> > +       status = "disabled";
>
> Wouldn't it be better to enable wdog2 and disable wdog1 instead? wdog2
> provides a POR, which is preferred.
Agree, thanks.