[PATCH v6 0/6] g_NCR5380: PDMA fixes and cleanup

[Finn Thain <fthain@telegraphics.com.au>]

Ondrej, would you please test this new series?

Changed since v1:
- PDMA transfer residual is calculated earlier.
- End of DMA flag check is now polled (if there is any residual).

Changed since v2:
- Bail out of transfer loops when Gated IRQ gets asserted.
- Make udelay conditional on board type.
- Drop sg_tablesize patch due to performance regression.

Changed since v3:
- Add Ondrej's workaround for corrupt WRITE commands on DTC boards.
- Reset the 53c400 logic after any short PDMA transfer.
- Don't fail the transfer if the 53c400 logic got a reset.

Changed since v4:
- Bail out of transfer loops when Gated IRQ gets asserted. (Again.)
- Always call wait_for_53c80_registers() at end of transfer.
- Drain chip buffers after PDMA receive is interrupted.
- Rework residual calculation.
- Add new patch to correct DMA terminology.

Changed since v5:
- Rework residual calculation to account for on-chip buffer swap.
- Attempt to retain the disconnect/IRQ detection in the DTC436 workaround.
- Move all DTC436 workarounds to final patch.


Finn Thain (2):
  g_NCR5380: Cleanup comments and whitespace
  g_NCR5380: Use unambiguous terminology for PDMA send and receive

Ondrej Zary (4):
  g_NCR5380: Fix PDMA transfer size
  g_NCR5380: End PDMA transfer correctly on target disconnection
  g_NCR5380: Re-work PDMA loops
  g_NCR5380: Various DTC436 workarounds

 drivers/scsi/g_NCR5380.c | 273 ++++++++++++++++++++++++++---------------------
 1 file changed, 151 insertions(+), 122 deletions(-)

-- 
2.13.0