linux-kernel.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
* [PATCH 00/31] arm64: zynqmp: Extend board description
@ 2021-06-09 11:44 Michal Simek
  2021-06-09 11:44 ` [PATCH 01/31] arm64: zynqmp: Disable CCI by default Michal Simek
                   ` (30 more replies)
  0 siblings, 31 replies; 37+ messages in thread
From: Michal Simek @ 2021-06-09 11:44 UTC (permalink / raw)
  To: linux-kernel, monstr, michal.simek, git, Viresh Kumar
  Cc: Amit Kumar Mahapatra, Geert Uytterhoeven, Krzysztof Kozlowski,
	Laurent Pinchart, Michael Walle, Quanyang Wang, Rob Herring,
	devicetree, linux-arm-kernel

Hi,

over years couple of drivers were upstream and it is time to sync it up.
On the top of it also adding new Kria boards which are using new overlay
infrastructure which check if that overlays can be applied to base DT file.

Thanks,
Michal


Amit Kumar Mahapatra (1):
  arm64: zynqmp: Do not duplicate flash partition label property

Michal Simek (27):
  arm64: zynqmp: Disable CCI by default
  arm64: zynqmp: Enable fpd_dma for zcu104 platforms
  arm64: zynqmp: Fix irps5401 device nodes
  arm64: zynqmp: Add pinctrl description for all boards
  arm64: zynqmp: Correct zcu111 psgtr description
  arm64: zynqmp: Wire psgtr for zc1751-xm015
  arm64: zynqmp: Correct psgtr description for zcu100-revC
  arm64: zynqmp: Add phy description for usb3.0
  arm64: zynqmp: Disable WP on zcu111
  arm64: zynqmp: Add missing mio-bank properties to dc1 and dc5
  arm64: zynqmp: Wire DP and DPDMA for dc1/dc4
  arm64: zynqmp: Enable nand driver for dc2 and dc3
  arm64: zynqmp: Remove additional newline
  arm64: zynqmp: Move clock node to zynqmp-clk-ccf.dtsi
  arm64: zynqmp: Add nvmem alises for eeproms
  arm64: zynqmp: List reset property for ethernet phy
  arm64: zynqmp: Remove can aliases from zc1751
  arm64: zynqmp: Move DP nodes to the end of file on zcu106
  arm64: zynqmp: Add note about UHS mode on some boards
  arm64: zynqmp: Remove information about dma clock on zcu106
  arm64: zynqmp: Wire qspi on multiple boards
  arm64: zynqmp: Move rtc to different location on zcu104-revA
  arm64: zynqmp: Add reset description for sata
  arm64: zynqmp: Sync psgtr node location with zcu104-revA
  arm64: zynqmp: Remove description for 8T49N287 and si5382 chips
  arm64: zynqmp: Add support for zcu102-rev1.1 board
  arm64: zynqmp: Add support for Xilinx Kria SOM board

Mounika Grace Akula (1):
  arm64: zynqmp: Add reset-on-timeout to all boards and modify default
    timeout value

Srinivas Neeli (1):
  arm64: zynqmp: Update rtc calibration value

Stefano Stabellini (1):
  arm64: zynqmp: Add missing SMID for pcie to zynqmp.dtsi

 .../devicetree/bindings/arm/xilinx.yaml       |  32 ++
 arch/arm64/boot/dts/xilinx/Makefile           |  12 +
 .../arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi |  13 +-
 .../boot/dts/xilinx/zynqmp-sck-kv-g-revA.dts  | 371 ++++++++++++++++++
 .../boot/dts/xilinx/zynqmp-sck-kv-g-revB.dts  | 351 +++++++++++++++++
 .../boot/dts/xilinx/zynqmp-sm-k26-revA.dts    | 289 ++++++++++++++
 .../boot/dts/xilinx/zynqmp-smk-k26-revA.dts   |  21 +
 .../boot/dts/xilinx/zynqmp-zc1232-revA.dts    |  16 +-
 .../boot/dts/xilinx/zynqmp-zc1254-revA.dts    |  16 +-
 .../dts/xilinx/zynqmp-zc1751-xm015-dc1.dts    | 289 +++++++++++++-
 .../dts/xilinx/zynqmp-zc1751-xm016-dc2.dts    | 335 +++++++++++++++-
 .../dts/xilinx/zynqmp-zc1751-xm017-dc3.dts    |   9 +-
 .../dts/xilinx/zynqmp-zc1751-xm018-dc4.dts    |  24 +-
 .../dts/xilinx/zynqmp-zc1751-xm019-dc5.dts    | 330 +++++++++++++++-
 .../boot/dts/xilinx/zynqmp-zcu100-revC.dts    | 254 +++++++++++-
 .../boot/dts/xilinx/zynqmp-zcu102-rev1.1.dts  |  15 +
 .../boot/dts/xilinx/zynqmp-zcu102-revA.dts    | 315 ++++++++++++++-
 .../boot/dts/xilinx/zynqmp-zcu102-revB.dts    |   3 +-
 .../boot/dts/xilinx/zynqmp-zcu104-revA.dts    | 286 +++++++++++++-
 .../boot/dts/xilinx/zynqmp-zcu104-revC.dts    | 244 +++++++++++-
 .../boot/dts/xilinx/zynqmp-zcu106-revA.dts    | 335 +++++++++++++++-
 .../boot/dts/xilinx/zynqmp-zcu111-revA.dts    | 269 ++++++++++++-
 arch/arm64/boot/dts/xilinx/zynqmp.dtsi        |  29 +-
 23 files changed, 3776 insertions(+), 82 deletions(-)
 create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dts
 create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dts
 create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
 create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-smk-k26-revA.dts
 create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-zcu102-rev1.1.dts

-- 
2.31.1


^ permalink raw reply	[flat|nested] 37+ messages in thread

end of thread, other threads:[~2021-06-16 11:17 UTC | newest]

Thread overview: 37+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2021-06-09 11:44 [PATCH 00/31] arm64: zynqmp: Extend board description Michal Simek
2021-06-09 11:44 ` [PATCH 01/31] arm64: zynqmp: Disable CCI by default Michal Simek
2021-06-09 11:44 ` [PATCH 02/31] arm64: zynqmp: Do not duplicate flash partition label property Michal Simek
2021-06-09 11:44 ` [PATCH 03/31] arm64: zynqmp: Enable fpd_dma for zcu104 platforms Michal Simek
2021-06-09 11:44 ` [PATCH 04/31] arm64: zynqmp: Fix irps5401 device nodes Michal Simek
2021-06-09 11:44 ` [PATCH 05/31] arm64: zynqmp: Add pinctrl description for all boards Michal Simek
2021-06-09 11:44 ` [PATCH 06/31] arm64: zynqmp: Correct zcu111 psgtr description Michal Simek
2021-06-09 11:44 ` [PATCH 07/31] arm64: zynqmp: Wire psgtr for zc1751-xm015 Michal Simek
2021-06-09 11:44 ` [PATCH 08/31] arm64: zynqmp: Correct psgtr description for zcu100-revC Michal Simek
2021-06-09 11:44 ` [PATCH 09/31] arm64: zynqmp: Add phy description for usb3.0 Michal Simek
2021-06-09 11:44 ` [PATCH 10/31] arm64: zynqmp: Disable WP on zcu111 Michal Simek
2021-06-09 11:44 ` [PATCH 11/31] arm64: zynqmp: Add missing SMID for pcie to zynqmp.dtsi Michal Simek
2021-06-09 11:44 ` [PATCH 12/31] arm64: zynqmp: Add missing mio-bank properties to dc1 and dc5 Michal Simek
2021-06-09 11:44 ` [PATCH 13/31] arm64: zynqmp: Wire DP and DPDMA for dc1/dc4 Michal Simek
2021-06-09 11:44 ` [PATCH 14/31] arm64: zynqmp: Enable nand driver for dc2 and dc3 Michal Simek
2021-06-09 11:44 ` [PATCH 15/31] arm64: zynqmp: Remove additional newline Michal Simek
2021-06-09 11:44 ` [PATCH 16/31] arm64: zynqmp: Move clock node to zynqmp-clk-ccf.dtsi Michal Simek
2021-06-09 11:44 ` [PATCH 17/31] arm64: zynqmp: Add nvmem alises for eeproms Michal Simek
2021-06-09 11:44 ` [PATCH 18/31] arm64: zynqmp: List reset property for ethernet phy Michal Simek
2021-06-09 11:44 ` [PATCH 19/31] arm64: zynqmp: Add reset-on-timeout to all boards and modify default timeout value Michal Simek
2021-06-09 11:44 ` [PATCH 20/31] arm64: zynqmp: Remove can aliases from zc1751 Michal Simek
2021-06-09 11:44 ` [PATCH 21/31] arm64: zynqmp: Move DP nodes to the end of file on zcu106 Michal Simek
2021-06-10  1:35   ` Laurent Pinchart
2021-06-09 11:44 ` [PATCH 22/31] arm64: zynqmp: Add note about UHS mode on some boards Michal Simek
2021-06-09 11:44 ` [PATCH 23/31] arm64: zynqmp: Update rtc calibration value Michal Simek
2021-06-09 11:45 ` [PATCH 24/31] arm64: zynqmp: Remove information about dma clock on zcu106 Michal Simek
2021-06-09 11:45 ` [PATCH 25/31] arm64: zynqmp: Wire qspi on multiple boards Michal Simek
2021-06-10  4:08   ` quanyang.wang
     [not found]     ` <d8d3f8e9-d59d-be12-05dd-5fa9b64cfcbe@xilinx.com>
2021-06-16 11:15       ` quanyang.wang
2021-06-09 11:45 ` [PATCH 26/31] arm64: zynqmp: Move rtc to different location on zcu104-revA Michal Simek
2021-06-09 11:45 ` [PATCH 27/31] arm64: zynqmp: Add reset description for sata Michal Simek
2021-06-09 11:45 ` [PATCH 28/31] arm64: zynqmp: Sync psgtr node location with zcu104-revA Michal Simek
2021-06-09 11:45 ` [PATCH 29/31] arm64: zynqmp: Remove description for 8T49N287 and si5382 chips Michal Simek
2021-06-09 11:45 ` [PATCH 30/31] arm64: zynqmp: Add support for zcu102-rev1.1 board Michal Simek
2021-06-09 11:45 ` [PATCH 31/31] arm64: zynqmp: Add support for Xilinx Kria SOM board Michal Simek
2021-06-09 12:04   ` Geert Uytterhoeven
2021-06-09 12:19     ` Michal Simek

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).