Re: [PATCH] net: phy: dp83867: fix irq generation

[Florian Fainelli <f.fainelli@gmail.com>]

On 01/05/2017 12:48 PM, Grygorii Strashko wrote:
> For proper IRQ generation by DP83867 phy the INT/PWDN pin has to be
> programmed as an interrupt output instead of a Powerdown input in
> Configuration Register 3 (CFG3), Address 0x001E, bit 7 INT_OE = 1. The
> current driver doesn't do this and as result IRQs will not be generated by
> DP83867 phy even if they are properly configured in DT.
> 
> Hence, fix IRQ generation by properly configuring CFG3.INT_OE bit and
> ensure that Link Status Change (LINK_STATUS_CHNG_INT) and Auto-Negotiation
> Complete (AUTONEG_COMP_INT) interrupt are enabled. After this the DP83867
> driver will work properly in interrupt enabled mode.
> 
> Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
> ---
>  drivers/net/phy/dp83867.c | 10 ++++++++++
>  1 file changed, 10 insertions(+)
> 
> diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c
> index 1b63924..e84ae08 100644
> --- a/drivers/net/phy/dp83867.c
> +++ b/drivers/net/phy/dp83867.c
> @@ -29,6 +29,7 @@
>  #define MII_DP83867_MICR	0x12
>  #define MII_DP83867_ISR		0x13
>  #define DP83867_CTRL		0x1f
> +#define DP83867_CFG3		0x1e
>  
>  /* Extended Registers */
>  #define DP83867_RGMIICTL	0x0032
> @@ -98,6 +99,8 @@ static int dp83867_config_intr(struct phy_device *phydev)
>  		micr_status |=
>  			(MII_DP83867_MICR_AN_ERR_INT_EN |
>  			MII_DP83867_MICR_SPEED_CHNG_INT_EN |
> +			MII_DP83867_MICR_AUTONEG_COMP_INT_EN |
> +			MII_DP83867_MICR_LINK_STS_CHNG_INT_EN |
>  			MII_DP83867_MICR_DUP_MODE_CHNG_INT_EN |
>  			MII_DP83867_MICR_SLEEP_MODE_CHNG_INT_EN);
>  
> @@ -214,6 +217,13 @@ static int dp83867_config_init(struct phy_device *phydev)
>  		}
>  	}
>  
> +	/* Enable Interrupt output INT_OE in CFG3 register */
> +	if (phy_interrupt_is_valid(phydev)) {
> +		val = phy_read(phydev, DP83867_CFG3);
> +		val |= BIT(7);
> +		phy_write(phydev, DP83867_CFG3, val);
> +	}

Don't you need to clear that bit in the case phy_interrupt_is_valid()
returns false?

Other than that:

Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
-- 
Florian