Re: [PATCH v3 2/3] thermal: broadcom: ns-thermal: default on iProc SoCs

[Scott Branden <scott.branden@broadcom.com>]

Hi Jon,


On 17-04-28 01:50 PM, Jon Mason wrote:
> On Fri, Apr 28, 2017 at 4:36 PM, Scott Branden
> <scott.branden@broadcom.com> wrote:
>>
>> On 17-04-28 01:11 PM, Jon Mason wrote:
>>> Tweak the Kconfig description to mention support for NSP and make the
>>> default on for iProc based platforms.
>>>
>>> Signed-off-by: Jon Mason <jon.mason@broadcom.com>
>>> ---
>>>   drivers/thermal/broadcom/Kconfig | 9 +++++----
>>>   1 file changed, 5 insertions(+), 4 deletions(-)
>>>
>>> diff --git a/drivers/thermal/broadcom/Kconfig
>>> b/drivers/thermal/broadcom/Kconfig
>>> index f0dea8a..b6f4b85 100644
>>> --- a/drivers/thermal/broadcom/Kconfig
>>> +++ b/drivers/thermal/broadcom/Kconfig
>>> @@ -1,8 +1,9 @@
>>>   config BCM_NS_THERMAL
>>>          tristate "Northstar thermal driver"
>>>          depends on ARCH_BCM_IPROC || COMPILE_TEST
>> If this driver is used on these SoCs then it:
>> depends on ARCH_BCM_NSP || ARCH_BCM_5301X || COMPILE_TEST
>> ?
> The code referenced is outside of this patch, as that code was already
> existing from when the driver was submitted.
>
> I did some checking and NS2 and Cygnus do not have the registers in
> use by this driver.  So, you are correct in that this driver will
> never be used for them.  So, this is slightly over-permissive in
> allowing a driver to be selected that could not ever be used on
> non-NS/NSP hardware.  But barring an incorrect DT string, it would
> only result in an slightly larger kernel than necessary.
>
> I'll do a follow-on patch to correct this with your suggestion above,
> and push it separately (unless a v4 is needed on this series).

Please submit the follow on patch.

>
> Thanks,
> Jon
Thanks,
  Scott