[PATCH V4 net-next 0/7] ARM: Enable GENET support for RPi 4

[Stefan Wahren <wahrenst@gmx.net>]

Raspberry Pi 4 uses the broadcom genet chip in version five.
This chip has a dma controller integrated. Up to now the maximal
burst size was hard-coded to 0x10. But it turns out that Raspberry Pi 4
does only work with the smaller maximal burst size of 0x8.

Additionally the patch series has some IRQ retrieval improvements and
adds support for a missing PHY mode.

This series based on Matthias Brugger's V1 series [1].

[1] - https://patchwork.kernel.org/cover/11186193/

Changes in V4:
- rebased on current net-next
- remove RGMII_ID support
- remove fixes tag from patch 1
- add Florian's suggestions to patch 5

Changes in V3:
- introduce SoC-specific compatibles for GENET (incl. dt-binding)
- use platform_get_irq_optional for optional IRQ
- remove Fixes tag from IRQ error handling change
- move most of MDIO stuff to bcm2711.dtsi

Changes in V2:
- add 2 fixes for IRQ retrieval
- add support for missing PHY modes
- declare PHY mode RGMII RXID based on the default settings
- add alias to allow firmware append the MAC address

Stefan Wahren (7):
  net: bcmgenet: Avoid touching non-existent interrupt
  net: bcmgenet: Fix error handling on IRQ retrieval
  dt-bindings: net: bcmgenet: Add BCM2711 support
  net: bcmgenet: Add BCM2711 support
  net: bcmgenet: Refactor register access in bcmgenet_mii_config
  net: bcmgenet: Add RGMII_RXID support
  ARM: dts: bcm2711-rpi-4: Enable GENET support

 .../devicetree/bindings/net/brcm,bcmgenet.txt      |  2 +-
 arch/arm/boot/dts/bcm2711-rpi-4-b.dts              | 17 +++++
 arch/arm/boot/dts/bcm2711.dtsi                     | 26 ++++++++
 drivers/net/ethernet/broadcom/genet/bcmgenet.c     | 74 ++++++++++++++++++----
 drivers/net/ethernet/broadcom/genet/bcmgenet.h     |  1 +
 drivers/net/ethernet/broadcom/genet/bcmmii.c       | 40 ++++++------
 6 files changed, 126 insertions(+), 34 deletions(-)

--
2.7.4