[PATCH net-next v1 1/1] net: usb: asix: ax88772: do not poll for PHY before registering it

[Oleksij Rempel <o.rempel@pengutronix.de>]

asix_get_phyid() is used for two reasons here. To print debug message
with the PHY ID and to wait until the PHY is powered up.

After migrating to the phylib, we can read PHYID from sysfs. If polling
for the PHY is really needed, then we will need to handle it in the
phylib as well.

This change was tested with:
- ax88772a + internal PHY
- ax88772b + external PHY

Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>
---
 drivers/net/usb/asix_devices.c | 5 -----
 1 file changed, 5 deletions(-)

diff --git a/drivers/net/usb/asix_devices.c b/drivers/net/usb/asix_devices.c
index 2c115216420a..049c20342a0b 100644
--- a/drivers/net/usb/asix_devices.c
+++ b/drivers/net/usb/asix_devices.c
@@ -714,7 +714,6 @@ static int ax88772_bind(struct usbnet *dev, struct usb_interface *intf)
 	u8 buf[ETH_ALEN] = {0}, chipcode = 0;
 	struct asix_common_private *priv;
 	int ret, i;
-	u32 phyid;
 
 	usbnet_get_endpoints(dev, intf);
 
@@ -762,10 +761,6 @@ static int ax88772_bind(struct usbnet *dev, struct usb_interface *intf)
 		return ret;
 	}
 
-	/* Read PHYID register *AFTER* the PHY was reset properly */
-	phyid = asix_get_phyid(dev);
-	netdev_dbg(dev->net, "PHYID=0x%08x\n", phyid);
-
 	/* Asix framing packs multiple eth frames into a 2K usb bulk transfer */
 	if (dev->driver_info->flags & FLAG_FRAMING_AX) {
 		/* hard_mtu  is still the default - the device does not support
-- 
2.30.2