On 26.10.2021 02:22:36, Vincent MAILHOL wrote: > Welcome back on the mailing list, hope you had some nice > holidays! Thanks was really nice, good weather, 1000km of cycling and hanging around in Vienna. :D > And also thanks a lot for your support over the last > few months on my other series to introduce the TDC netlink > interface :) The pleasure is on my side, working with you! > Le lun. 25 oct. 2021 à 03:30, Marc Kleine-Budde a écrit : > > > > On 09.10.2021 22:13:02, Vincent Mailhol wrote: > > > The statically enabled features of a CAN controller can be retrieved > > > using below formula: > > > > > > | u32 ctrlmode_static = priv->ctrlmode & ~priv->ctrlmode_supported; > > > > > > As such, there is no need to store this information. This patch remove > > > the field ctrlmode_static of struct can_priv and provides, in > > > replacement, the inline function can_get_static_ctrlmode() which > > > returns the same value. > > > > > > A condition sine qua non for this to work is that the controller > > > static modes should never be set in can_priv::ctrlmode_supported. This > > > is already the case for existing drivers, however, we added a warning > > > message in can_set_static_ctrlmode() to check that. > > > > Please make the can_set_static_ctrlmode to return an error in case of a > > problem. Adjust the drivers using the function is this patch, too. > > I didn't do so initially because this is more a static > configuration issue that should only occur during > development. Nonetheless, what you suggest is really simple. > > I will just split the patch in two: one of the setter and one for > the getter and address your comments. Fine with me. Most important thing is, that the kernel compiles after each patch. regards, Marc -- Pengutronix e.K. | Marc Kleine-Budde | Embedded Linux | https://www.pengutronix.de | Vertretung West/Dortmund | Phone: +49-231-2826-924 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |