It was <2020-10-03 sob 12:13>, when Krzysztof Kozlowski wrote:
> On Fri, 2 Oct 2020 at 21:22, Łukasz Stelmach <l.stelmach@samsung.com> wrote:
>>
>> Add node for ax88796c ethernet chip.
>>
>> Signed-off-by: Łukasz Stelmach <l.stelmach@samsung.com>
>> ---
>>  arch/arm/boot/dts/exynos3250-artik5-eval.dts | 21 ++++++++++++++++++++
>>  1 file changed, 21 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/exynos3250-artik5-eval.dts b/arch/arm/boot/dts/exynos3250-artik5-eval.dts
>> index 20446a846a98..7f115c348a2a 100644
>> --- a/arch/arm/boot/dts/exynos3250-artik5-eval.dts
>> +++ b/arch/arm/boot/dts/exynos3250-artik5-eval.dts
>> @@ -37,3 +37,24 @@ &mshc_2 {
>>  &serial_2 {
>>         status = "okay";
>>  };
>> +
>> +&spi_0 {
>> +       status = "okay";
>> +       cs-gpios = <&gpx3 4 GPIO_ACTIVE_LOW>, <0>;
>> +
>> +       assigned-clocks        = <&cmu CLK_MOUT_MPLL>, <&cmu CLK_DIV_MPLL_PRE>, <&cmu CLK_MOUT_SPI0>,    <&cmu CLK_DIV_SPI0>,  <&cmu CLK_DIV_SPI0_PRE>, <&cmu CLK_SCLK_SPI0>;
>
> No spaces before or after '='.
>

You mean " = ", don't you?

>> + assigned-clock-parents = <&cmu CLK_FOUT_MPLL>, <&cmu
>> CLK_MOUT_MPLL>, <&cmu CLK_DIV_MPLL_PRE>, <&cmu CLK_MOUT_SPI0>, <&cmu
>> CLK_DIV_SPI0>, <&cmu CLK_DIV_SPI0_PRE>;
>
> This line is still too long. Please wrap it at 80. Checkpatch should
> complain about it... so it seems you did not run it. Please fix all
> checkpatch issues.

My idea was too keep assigned-clocks and assigned-clock-parrent lines
aligned, so it is clearly visible which parrent applies to which
clock. Is it inappropriate?

>> +
>> +       ax88796c@0 {
>> +               compatible = "asix,ax88796c";
>> +               local-mac-address = [00 00 00 00 00 00]; /* Filled in by a boot-loader */
>> +               interrupt-parent = <&gpx2>;
>> +               interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
>> +               spi-max-frequency = <40000000>;
>> +               reg = <0x0>;
>
> Put reg after compatible.

Done.

-- 
Łukasz Stelmach
Samsung R&D Institute Poland
Samsung Electronics