[0/6] ARM: dts: qcom-msm8974: change invalid flag IRQ NONE to valid value
mbox series

Message ID 1536298394-5548-1-git-send-email-frowand.list@gmail.com
Headers show
Series
  • ARM: dts: qcom-msm8974: change invalid flag IRQ NONE to valid value
Related show

Message

Frank Rowand Sept. 7, 2018, 5:33 a.m. UTC
From: Frank Rowand <frank.rowand@sony.com>

A boot time warning of devicetree interrupts types set to the invalid
value of none was added by 83a86fbb5b56 ("irqchip/gic: Loudly complain
about the use of IRQ_TYPE_NONE").  This patch series fixes the
devicetree source to replace IRQ_TYPE_NONE with the appropriate
value.

Some cosmetic changes are made by several patches.  The final patch
in the series replaces the IRQ_TYPE_NONE values with the proper
values.

The cosmetic changes are to change integer values in the third field
of the "interrupts" property to the correct named constant.

Bjorn suggested that I also change integer values in the first field
of the "interrupts" property to the correct named constant.

The series is split into several patches for ease of review.  Each
cosmetic patch addresses a single named constant.


Frank Rowand (6):
  ARM: dts: qcom-msm8974: use named constant for interrupt type GIC_PPI
  ARM: dts: qcom-msm8974: use named constant for interrupt type GIC_SPI
  ARM: dts: qcom-msm8974: use named constant for interrupt flag EDGE
    RISING
  ARM: dts: qcom-msm8974: use named constant for interrupt flag LEVEL
    HIGH
  ARM: dts: qcom-msm8974: use named constant for interrupt flag NONE
  ARM: dts: qcom-msm8974: change invalid flag IRQ NONE to valid value

 arch/arm/boot/dts/qcom-msm8974.dtsi | 72 +++++++++++++++++++------------------
 1 file changed, 37 insertions(+), 35 deletions(-)