From: Daniel Lezcano <daniel.lezcano@linaro.org>
To: tglx@linutronix.de
Cc: linux-kernel@vger.kernel.org, Biju Das <biju.das@bp.renesas.com>,
Rob Herring <robh+dt@kernel.org>,
Mark Rutland <mark.rutland@arm.com>,
devicetree@vger.kernel.org (open list:OPEN FIRMWARE AND
FLATTENED DEVICE TREE BINDINGS)
Subject: [PATCH 14/25] dt-bindings: timer: renesas, cmt: Document r8a774a1 CMT support
Date: Tue, 18 Dec 2018 22:28:32 +0100 [thread overview]
Message-ID: <20181218212844.30445-14-daniel.lezcano@linaro.org> (raw)
In-Reply-To: <20181218212844.30445-1-daniel.lezcano@linaro.org>
From: Biju Das <biju.das@bp.renesas.com>
Document SoC specific bindings for RZ/G2M (r8a774a1) SoC.
Signed-off-by: Biju Das <biju.das@bp.renesas.com>
Reviewed-by: Simon Horman <horms+renesas@verge.net.au>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
---
.../devicetree/bindings/timer/renesas,cmt.txt | 11 ++++++++---
1 file changed, 8 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/timer/renesas,cmt.txt b/Documentation/devicetree/bindings/timer/renesas,cmt.txt
index eb602c599341..862a80f0380a 100644
--- a/Documentation/devicetree/bindings/timer/renesas,cmt.txt
+++ b/Documentation/devicetree/bindings/timer/renesas,cmt.txt
@@ -30,6 +30,8 @@ Required Properties:
- "renesas,r8a7745-cmt1" for the 48-bit CMT1 device included in r8a7745.
- "renesas,r8a77470-cmt0" for the 32-bit CMT0 device included in r8a77470.
- "renesas,r8a77470-cmt1" for the 48-bit CMT1 device included in r8a77470.
+ - "renesas,r8a774a1-cmt0" for the 32-bit CMT0 device included in r8a774a1.
+ - "renesas,r8a774a1-cmt1" for the 48-bit CMT1 device included in r8a774a1.
- "renesas,r8a7790-cmt0" for the 32-bit CMT0 device included in r8a7790.
- "renesas,r8a7790-cmt1" for the 48-bit CMT1 device included in r8a7790.
- "renesas,r8a7791-cmt0" for the 32-bit CMT0 device included in r8a7791.
@@ -51,9 +53,12 @@ Required Properties:
and RZ/G1.
These are fallbacks for r8a73a4, R-Car Gen2 and RZ/G1 entries
listed above.
- - "renesas,rcar-gen3-cmt0" for 32-bit CMT0 devices included in R-Car Gen3.
- - "renesas,rcar-gen3-cmt1" for 48-bit CMT1 devices included in R-Car Gen3.
- These are fallbacks for R-Car Gen3 entries listed above.
+ - "renesas,rcar-gen3-cmt0" for 32-bit CMT0 devices included in R-Car Gen3
+ and RZ/G2.
+ - "renesas,rcar-gen3-cmt1" for 48-bit CMT1 devices included in R-Car Gen3
+ and RZ/G2.
+ These are fallbacks for R-Car Gen3 and RZ/G2 entries listed
+ above.
- reg: base address and length of the registers block for the timer module.
- interrupts: interrupt-specifier for the timer, one per channel.
--
2.17.1
next prev parent reply other threads:[~2018-12-18 21:29 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-12-18 21:27 [GIT PULL] timers for 4.21 Daniel Lezcano
2018-12-18 21:28 ` [PATCH 01/25] clocksource/drivers/timer-vt8500: Remove duplicate function name Daniel Lezcano
2018-12-18 21:28 ` [PATCH 02/25] clocksource/drivers/dbx500: Demote dbx500 PRCMU clocksource Daniel Lezcano
2018-12-18 21:28 ` [PATCH 03/25] clocksource/drivers/ux500: Drop Ux500 custom SCHED_CLOCK Daniel Lezcano
2018-12-18 21:28 ` [PATCH 04/25] clocksource/drivers/timer-ti-dm: Remove the early platform driver registration Daniel Lezcano
2018-12-18 21:28 ` [PATCH 05/25] clockevents/drivers/tegra20: Remove obsolete inclusion of <asm/smp_twd.h> Daniel Lezcano
2018-12-18 21:28 ` [PATCH 06/25] clocksource/drivers/meson6_timer: Use register names from the datasheet Daniel Lezcano
2018-12-18 21:28 ` [PATCH 07/25] clocksource/drivers/meson6_timer: Implement the ARM delay timer Daniel Lezcano
2018-12-18 21:28 ` [PATCH 08/25] clocksource/drivers/imx-gpt: Add support for ARM64 Daniel Lezcano
2018-12-18 21:28 ` [PATCH 09/25] clocksource/drivers/imx-gpt: Remove unnecessary irq protection Daniel Lezcano
2018-12-18 21:28 ` [PATCH 10/25] dt-bindings: timer: renesas, cmt: Document r8a7796 CMT support Daniel Lezcano
2018-12-18 21:28 ` [PATCH 11/25] dt-bindings: timer: renesas, cmt: Document r8a77470 " Daniel Lezcano
2018-12-18 21:28 ` [PATCH 12/25] clocksource/drivers/arc_timer: Utilize generic sched_clock Daniel Lezcano
[not found] ` <20181219012457.EC02721871@mail.kernel.org>
2018-12-19 9:06 ` Alexey Brodkin
2018-12-18 21:28 ` [PATCH 13/25] clocksource/drivers/timer-imx-tpm: Convert the driver to timer-of Daniel Lezcano
2018-12-18 21:28 ` Daniel Lezcano [this message]
2018-12-18 21:28 ` [PATCH 15/25] clocksource/drivers/bcm2835: Switch to SPDX identifier Daniel Lezcano
2018-12-18 21:28 ` [PATCH 16/25] clocksource/drivers/integrator-ap: Add missing of_node_put() Daniel Lezcano
2018-12-18 21:28 ` [PATCH 17/25] clocksource/drivers/fttmr010: Fix invalid interrupt register access Daniel Lezcano
2018-12-18 21:28 ` [PATCH 18/25] clocksource/drivers/timer-imx-tpm: Specify clock name for timer-of Daniel Lezcano
2018-12-18 21:28 ` [PATCH 19/25] clocksource/drivers/riscv_timer: Provide the sched_clock Daniel Lezcano
2018-12-18 21:28 ` [PATCH 20/25] clocksource/drivers/riscv: Change name riscv_timer to timer-riscv Daniel Lezcano
2018-12-18 21:28 ` [PATCH 21/25] clocksource/drivers/rockchip: Change name rockchip_timer to timer-rockchip Daniel Lezcano
2018-12-18 21:28 ` [PATCH 22/25] clocksource/drivers/tegra20: Change name tegra20_timer to timer-tegra20 Daniel Lezcano
2018-12-18 21:28 ` [PATCH 23/25] clocksource/drivers/sun4i: Change name sun4i_timer to timer-sun4i Daniel Lezcano
2018-12-18 21:28 ` [PATCH 24/25] clocksource/drivers/meson6: Change name meson6_timer timer-meson6 Daniel Lezcano
2018-12-18 21:28 ` [PATCH 25/25] clocksource/drivers/rda: Add clock driver for RDA8810PL SoC Daniel Lezcano
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20181218212844.30445-14-daniel.lezcano@linaro.org \
--to=daniel.lezcano@linaro.org \
--cc=biju.das@bp.renesas.com \
--cc=devicetree@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=robh+dt@kernel.org \
--cc=tglx@linutronix.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).