From: Masahiro Yamada <yamada.masahiro@socionext.com>
To: linux-mtd@lists.infradead.org, Miquel Raynal <miquel.raynal@bootlin.com>
Cc: Boris Brezillon <bbrezillon@kernel.org>,
Masahiro Yamada <yamada.masahiro@socionext.com>,
Brian Norris <computersforpeace@gmail.com>,
linux-kernel@vger.kernel.org, Marek Vasut <marek.vasut@gmail.com>,
Richard Weinberger <richard@nod.at>,
David Woodhouse <dwmw2@infradead.org>
Subject: [PATCH v2 06/10] mtd: rawnand: denali: use bool type instead of int where appropriate
Date: Tue, 12 Feb 2019 16:12:58 +0900 [thread overview]
Message-ID: <1549955582-30346-7-git-send-email-yamada.masahiro@socionext.com> (raw)
In-Reply-To: <1549955582-30346-1-git-send-email-yamada.masahiro@socionext.com>
Use 'bool' type for the following boolean parameters.
- write (write or read?)
- raw (raw access or not?)
- dma_avail (DMA engine available or not?)
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
---
Changes in v2:
- Use bool for dma_avail as well
drivers/mtd/nand/raw/denali.c | 27 ++++++++++++++-------------
drivers/mtd/nand/raw/denali.h | 4 ++--
2 files changed, 16 insertions(+), 15 deletions(-)
diff --git a/drivers/mtd/nand/raw/denali.c b/drivers/mtd/nand/raw/denali.c
index 7050b1f..f539731 100644
--- a/drivers/mtd/nand/raw/denali.c
+++ b/drivers/mtd/nand/raw/denali.c
@@ -360,7 +360,7 @@ static int denali_sw_ecc_fixup(struct nand_chip *chip,
}
static void denali_setup_dma64(struct denali_nand_info *denali,
- dma_addr_t dma_addr, int page, int write)
+ dma_addr_t dma_addr, int page, bool write)
{
uint32_t mode;
const int page_count = 1;
@@ -374,7 +374,8 @@ static void denali_setup_dma64(struct denali_nand_info *denali,
* burst len = 64 bytes, the number of pages
*/
denali->host_write(denali, mode,
- 0x01002000 | (64 << 16) | (write << 8) | page_count);
+ 0x01002000 | (64 << 16) |
+ (write ? BIT(8) : 0) | page_count);
/* 2. set memory low address */
denali->host_write(denali, mode, lower_32_bits(dma_addr));
@@ -384,7 +385,7 @@ static void denali_setup_dma64(struct denali_nand_info *denali,
}
static void denali_setup_dma32(struct denali_nand_info *denali,
- dma_addr_t dma_addr, int page, int write)
+ dma_addr_t dma_addr, int page, bool write)
{
uint32_t mode;
const int page_count = 1;
@@ -395,7 +396,7 @@ static void denali_setup_dma32(struct denali_nand_info *denali,
/* 1. setup transfer type and # of pages */
denali->host_write(denali, mode | page,
- 0x2000 | (write << 8) | page_count);
+ 0x2000 | (write ? BIT(8) : 0) | page_count);
/* 2. set memory high address bits 23:8 */
denali->host_write(denali, mode | ((dma_addr >> 16) << 8), 0x2200);
@@ -457,7 +458,7 @@ static int denali_pio_write(struct denali_nand_info *denali, const u32 *buf,
}
static int denali_pio_xfer(struct denali_nand_info *denali, void *buf,
- size_t size, int page, int write)
+ size_t size, int page, bool write)
{
if (write)
return denali_pio_write(denali, buf, size, page);
@@ -466,7 +467,7 @@ static int denali_pio_xfer(struct denali_nand_info *denali, void *buf,
}
static int denali_dma_xfer(struct denali_nand_info *denali, void *buf,
- size_t size, int page, int write)
+ size_t size, int page, bool write)
{
dma_addr_t dma_addr;
uint32_t irq_mask, irq_status, ecc_err_mask;
@@ -523,7 +524,7 @@ static int denali_dma_xfer(struct denali_nand_info *denali, void *buf,
}
static int denali_data_xfer(struct nand_chip *chip, void *buf, size_t size,
- int page, int raw, int write)
+ int page, bool raw, bool write)
{
struct denali_nand_info *denali = to_denali(chip);
@@ -648,7 +649,7 @@ static int denali_read_page_raw(struct nand_chip *chip, uint8_t *buf,
if (!buf)
return -EINVAL;
- ret = denali_data_xfer(chip, tmp_buf, size, page, 1, 0);
+ ret = denali_data_xfer(chip, tmp_buf, size, page, true, false);
if (ret)
return ret;
@@ -704,7 +705,7 @@ static int denali_write_page_raw(struct nand_chip *chip, const uint8_t *buf,
return ret;
}
- return denali_data_xfer(chip, tmp_buf, size, page, 1, 1);
+ return denali_data_xfer(chip, tmp_buf, size, page, true, true);
}
static int denali_change_read_column_op(void *buf, unsigned int offset,
@@ -756,7 +757,7 @@ static int denali_read_page(struct nand_chip *chip, uint8_t *buf,
int stat = 0;
int ret;
- ret = denali_data_xfer(chip, buf, mtd->writesize, page, 0, 0);
+ ret = denali_data_xfer(chip, buf, mtd->writesize, page, false, false);
if (ret && ret != -EBADMSG)
return ret;
@@ -786,7 +787,7 @@ static int denali_write_page(struct nand_chip *chip, const uint8_t *buf,
struct mtd_info *mtd = nand_to_mtd(chip);
return denali_data_xfer(chip, (void *)buf, mtd->writesize, page,
- 0, 1);
+ false, true);
}
static int denali_setup_data_interface(struct nand_chip *chip, int chipnr,
@@ -1042,7 +1043,7 @@ static int denali_attach_chip(struct nand_chip *chip)
int ret;
if (ioread32(denali->reg + FEATURES) & FEATURES__DMA)
- denali->dma_avail = 1;
+ denali->dma_avail = true;
if (denali->dma_avail) {
int dma_bit = denali->caps & DENALI_CAP_DMA_64BIT ? 64 : 32;
@@ -1051,7 +1052,7 @@ static int denali_attach_chip(struct nand_chip *chip)
if (ret) {
dev_info(denali->dev,
"Failed to set DMA mask. Disabling DMA.\n");
- denali->dma_avail = 0;
+ denali->dma_avail = false;
}
}
diff --git a/drivers/mtd/nand/raw/denali.h b/drivers/mtd/nand/raw/denali.h
index c8c2620..8552b3f 100644
--- a/drivers/mtd/nand/raw/denali.h
+++ b/drivers/mtd/nand/raw/denali.h
@@ -304,7 +304,7 @@ struct denali_nand_info {
u32 irq_status; /* interrupts that have happened */
int irq;
void *buf; /* for syndrome layout conversion */
- int dma_avail; /* can support DMA? */
+ bool dma_avail; /* can support DMA? */
int devs_per_cs; /* devices connected in parallel */
int oob_skip_bytes; /* number of bytes reserved for BBM */
int max_banks;
@@ -314,7 +314,7 @@ struct denali_nand_info {
u32 (*host_read)(struct denali_nand_info *denali, u32 addr);
void (*host_write)(struct denali_nand_info *denali, u32 addr, u32 data);
void (*setup_dma)(struct denali_nand_info *denali, dma_addr_t dma_addr,
- int page, int write);
+ int page, bool write);
};
#define DENALI_CAP_HW_ECC_FIXUP BIT(0)
--
2.7.4
next prev parent reply other threads:[~2019-02-12 7:14 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-02-12 7:12 [PATCH v2 00/10] mtd: rawnand: denali: exec_op(), controller/chip separation, and cleanups Masahiro Yamada
2019-02-12 7:12 ` [PATCH v2 01/10] mtd: rawnand: denali: use nand_chip pointer more for internal functions Masahiro Yamada
2019-02-12 7:12 ` [PATCH v2 02/10] mtd: rawnand: denali: refactor syndrome layout handling for raw access Masahiro Yamada
2019-03-04 9:01 ` Miquel Raynal
2019-03-05 9:20 ` Masahiro Yamada
2019-03-05 17:55 ` Miquel Raynal
2019-02-12 7:12 ` [PATCH v2 03/10] mtd: rawnand: denali: remove unneeded casts in denali_{read,write}_pio Masahiro Yamada
2019-02-12 7:12 ` [PATCH v2 04/10] mtd: rawnand: denali: switch over to ->exec_op() from legacy hooks Masahiro Yamada
2019-03-04 9:30 ` Miquel Raynal
2019-03-05 7:13 ` Masahiro Yamada
2019-02-12 7:12 ` [PATCH v2 05/10] mtd: rawnand: denali: use more precise timeout for NAND_OP_WAITRDT_INSTR Masahiro Yamada
2019-03-04 8:43 ` Miquel Raynal
2019-03-05 6:36 ` Masahiro Yamada
2019-02-12 7:12 ` Masahiro Yamada [this message]
2019-02-12 7:12 ` [PATCH v2 07/10] mtd: rawnand: denali_pci: rename goto labels Masahiro Yamada
2019-02-12 7:13 ` [PATCH v2 08/10] mtd: rawnand: denali: decouple controller and NAND chips Masahiro Yamada
2019-02-18 20:01 ` Rob Herring
2019-02-12 7:13 ` [PATCH v2 09/10] mtd: rawnand: denali: remove DENALI_NR_BANKS macro Masahiro Yamada
2019-02-12 7:13 ` [PATCH v2 10/10] mtd: rawnand: denali: clean up coding style Masahiro Yamada
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1549955582-30346-7-git-send-email-yamada.masahiro@socionext.com \
--to=yamada.masahiro@socionext.com \
--cc=bbrezillon@kernel.org \
--cc=computersforpeace@gmail.com \
--cc=dwmw2@infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=marek.vasut@gmail.com \
--cc=miquel.raynal@bootlin.com \
--cc=richard@nod.at \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).