From: Soeren Moch <smoch@web.de>
To: Kalle Valo <kvalo@codeaurora.org>
Cc: Soeren Moch <smoch@web.de>, Heiko Stuebner <heiko@sntech.de>,
linux-wireless@vger.kernel.org,
brcm80211-dev-list.pdl@broadcom.com,
brcm80211-dev-list@cypress.com, netdev@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org
Subject: [PATCH 8/8] arm64: dts: rockchip: RockPro64: enable wifi module at sdio0
Date: Mon, 9 Dec 2019 23:38:22 +0100 [thread overview]
Message-ID: <20191209223822.27236-8-smoch@web.de> (raw)
In-Reply-To: <20191209223822.27236-1-smoch@web.de>
RockPro64 supports an Ampak AP6359SA based wifi/bt combo module.
The BCM4359/9 wifi controller in this module is connected to sdio0,
enable this interface.
Signed-off-by: Soeren Moch <smoch@web.de>
---
Not sure where to place exactly the sdio0 node in the dts because
existing sd nodes are not sorted alphabetically.
This last patch in this brcmfmac patch series probably should be picked
up by Heiko independently of the rest of this series. It was sent together
to show how this brcmfmac extension for 4359-sdio support with RSDB is
used and tested.
Cc: Heiko Stuebner <heiko@sntech.de>
Cc: Kalle Valo <kvalo@codeaurora.org>
Cc: linux-wireless@vger.kernel.org
Cc: brcm80211-dev-list.pdl@broadcom.com
Cc: brcm80211-dev-list@cypress.com
Cc: netdev@vger.kernel.org
Cc: linux-arm-kernel@lists.infradead.org
Cc: linux-rockchip@lists.infradead.org
Cc: linux-kernel@vger.kernel.org
---
.../boot/dts/rockchip/rk3399-rockpro64.dts | 21 ++++++++++++-------
1 file changed, 14 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts b/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
index 7f4b2eba31d4..9fa92790d6e0 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
@@ -71,13 +71,6 @@
clock-names = "ext_clock";
pinctrl-names = "default";
pinctrl-0 = <&wifi_enable_h>;
-
- /*
- * On the module itself this is one of these (depending
- * on the actual card populated):
- * - SDIO_RESET_L_WL_REG_ON
- * - PDN (power down when low)
- */
reset-gpios = <&gpio0 RK_PB2 GPIO_ACTIVE_LOW>;
};
@@ -650,6 +643,20 @@
status = "okay";
};
+&sdio0 {
+ bus-width = <4>;
+ cap-sd-highspeed;
+ cap-sdio-irq;
+ disable-wp;
+ keep-power-in-suspend;
+ mmc-pwrseq = <&sdio_pwrseq>;
+ non-removable;
+ pinctrl-names = "default";
+ pinctrl-0 = <&sdio0_bus4 &sdio0_cmd &sdio0_clk>;
+ sd-uhs-sdr104;
+ status = "okay";
+};
+
&sdmmc {
bus-width = <4>;
cap-sd-highspeed;
--
2.17.1
next prev parent reply other threads:[~2019-12-09 22:38 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-12-09 22:38 [PATCH 1/8] brcmfmac: reset two D11 cores if chip has two D11 cores Soeren Moch
2019-12-09 22:38 ` [PATCH 2/8] brcmfmac: set F2 blocksize and watermark for 4359 Soeren Moch
2019-12-10 3:37 ` Chi-Hsien Lin
2019-12-09 22:38 ` [PATCH 3/8] brcmfmac: fix rambase for 4359/9 Soeren Moch
2019-12-09 22:38 ` [PATCH 4/8] brcmfmac: make errors when setting roaming parameters non-fatal Soeren Moch
2019-12-10 3:37 ` Chi-Hsien Lin
2019-12-09 22:38 ` [PATCH 5/8] brcmfmac: add support for BCM4359 SDIO chipset Soeren Moch
2019-12-10 3:38 ` Chi-Hsien Lin
2019-12-10 6:32 ` Chi-Hsien Lin
2019-12-10 10:12 ` Soeren Moch
2019-12-09 22:38 ` [PATCH 6/8] brcmfmac: add RSDB condition when setting interface combinations Soeren Moch
2019-12-10 3:38 ` Chi-Hsien Lin
2019-12-09 22:38 ` [PATCH 7/8] brcmfmac: not set mbss in vif if firmware does not support MBSS Soeren Moch
2019-12-10 3:38 ` Chi-Hsien Lin
2019-12-09 22:38 ` Soeren Moch [this message]
2019-12-09 23:08 ` [PATCH 8/8] arm64: dts: rockchip: RockPro64: enable wifi module at sdio0 Heiko Stübner
2019-12-09 23:29 ` Soeren Moch
2019-12-10 1:18 ` Heiko Stübner
2019-12-10 9:14 ` Kalle Valo
2019-12-10 10:08 ` Soeren Moch
2019-12-10 10:13 ` Heiko Stübner
[not found] ` <5d3bde69-9102-cc81-c1d2-d71b60258906@web.de>
2019-12-11 15:50 ` Soeren Moch
[not found] ` <0101016eef171394-2c71e1b8-45b9-4e38-96f9-2841dd0607ba-000000@us-west-2.amazonses.com>
2019-12-10 10:15 ` Soeren Moch
2019-12-10 3:36 ` [PATCH 1/8] brcmfmac: reset two D11 cores if chip has two D11 cores Chi-Hsien Lin
2019-12-10 9:08 ` Kalle Valo
[not found] ` <0101016eef117d24-d6de85e6-6356-4c73-bff4-f787e8c982bc-000000@us-west-2.amazonses.com>
2019-12-10 10:14 ` Soeren Moch
2019-12-10 10:20 ` Kalle Valo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20191209223822.27236-8-smoch@web.de \
--to=smoch@web.de \
--cc=brcm80211-dev-list.pdl@broadcom.com \
--cc=brcm80211-dev-list@cypress.com \
--cc=heiko@sntech.de \
--cc=kvalo@codeaurora.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=linux-wireless@vger.kernel.org \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).