[PATCH 3/8] ata: ahci_brcm: BCM7425 AHCI requires AHCI_HFLAG_DELAY_ENGINE

From: Florian Fainelli <f.fainelli@gmail.com>
To: linux-kernel@vger.kernel.org
Cc: bcm-kernel-feedback-list@broadcom.com,
	Florian Fainelli <f.fainelli@gmail.com>,
	Jens Axboe <axboe@kernel.dk>, Rob Herring <robh+dt@kernel.org>,
	Mark Rutland <mark.rutland@arm.com>,
	Hans de Goede <hdegoede@redhat.com>,
	Philipp Zabel <p.zabel@pengutronix.de>, Tejun Heo <tj@kernel.org>,
	Jaedon Shin <jaedon.shin@gmail.com>,
	linux-ide@vger.kernel.org (open list:LIBATA SUBSYSTEM (Serial
	and Parallel ATA drivers)),
	devicetree@vger.kernel.org (open list:OPEN FIRMWARE AND
	FLATTENED DEVICE TREE BINDINGS)
Subject: [PATCH 3/8] ata: ahci_brcm: BCM7425 AHCI requires AHCI_HFLAG_DELAY_ENGINE
Date: Tue, 10 Dec 2019 10:53:46 -0800	[thread overview]
Message-ID: <20191210185351.14825-4-f.fainelli@gmail.com> (raw)
In-Reply-To: <20191210185351.14825-1-f.fainelli@gmail.com>

Set AHCI_HFLAG_DELAY_ENGINE for the BCM7425 AHCI controller thus making
it conforming to the 'strict' AHCI implementation which this controller
is based on.

This solves long link establishment with specific hard drives (e.g.:
Seagate ST1000VM002-9ZL1 SC12) that would otherwise have to complete the
error recovery handling before finally establishing a succesful SATA
link at the desired speed.

We re-order the hpriv->flags assignment to also remove the NONCQ quirk
since we can set the flag directly.

Fixes: 9586114cf1e9 ("ata: ahci_brcmstb: add support MIPS-based platforms")
Fixes: 423be77daabe ("ata: ahci_brcmstb: add quirk for broken ncq")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
---
 drivers/ata/ahci_brcm.c | 31 ++++++++++++++++---------------
 1 file changed, 16 insertions(+), 15 deletions(-)

diff --git a/drivers/ata/ahci_brcm.c b/drivers/ata/ahci_brcm.c
index a8b2f3f7bbbc..58f8fd7bb8b8 100644
--- a/drivers/ata/ahci_brcm.c
+++ b/drivers/ata/ahci_brcm.c
@@ -76,8 +76,7 @@ enum brcm_ahci_version {
 };
 
 enum brcm_ahci_quirks {
-	BRCM_AHCI_QUIRK_NO_NCQ		= BIT(0),
-	BRCM_AHCI_QUIRK_SKIP_PHY_ENABLE	= BIT(1),
+	BRCM_AHCI_QUIRK_SKIP_PHY_ENABLE	= BIT(0),
 };
 
 struct brcm_ahci_priv {
@@ -432,18 +431,27 @@ static int brcm_ahci_probe(struct platform_device *pdev)
 	if (!IS_ERR_OR_NULL(priv->rcdev))
 		reset_control_deassert(priv->rcdev);
 
-	if ((priv->version == BRCM_SATA_BCM7425) ||
-		(priv->version == BRCM_SATA_NSP)) {
-		priv->quirks |= BRCM_AHCI_QUIRK_NO_NCQ;
-		priv->quirks |= BRCM_AHCI_QUIRK_SKIP_PHY_ENABLE;
-	}
-
 	hpriv = ahci_platform_get_resources(pdev, 0);
 	if (IS_ERR(hpriv)) {
 		ret = PTR_ERR(hpriv);
 		goto out_reset;
 	}
 
+	hpriv->plat_data = priv;
+	hpriv->flags = AHCI_HFLAG_WAKE_BEFORE_STOP | AHCI_HFLAG_NO_WRITE_TO_RO;
+
+	switch (priv->version) {
+	case BRCM_SATA_BCM7425:
+		hpriv->flags |= AHCI_HFLAG_DELAY_ENGINE;
+		/* fall through */
+	case BRCM_SATA_NSP:
+		hpriv->flags |= AHCI_HFLAG_NO_NCQ;
+		priv->quirks |= BRCM_AHCI_QUIRK_SKIP_PHY_ENABLE;
+		break;
+	default:
+		break;
+	}
+
 	ret = ahci_platform_enable_clks(hpriv);
 	if (ret)
 		goto out_reset;
@@ -463,15 +471,8 @@ static int brcm_ahci_probe(struct platform_device *pdev)
 	/* Must be done before ahci_platform_enable_phys() */
 	brcm_sata_phys_enable(priv);
 
-	hpriv->plat_data = priv;
-	hpriv->flags = AHCI_HFLAG_WAKE_BEFORE_STOP;
-
 	brcm_sata_alpm_init(hpriv);
 
-	if (priv->quirks & BRCM_AHCI_QUIRK_NO_NCQ)
-		hpriv->flags |= AHCI_HFLAG_NO_NCQ;
-	hpriv->flags |= AHCI_HFLAG_NO_WRITE_TO_RO;
-
 	ret = ahci_platform_enable_phys(hpriv);
 	if (ret)
 		goto out_disable_phys;
-- 
2.17.1

